unfortunately dave has stopped making them.
its one of those things you're going to have to cough up for unfortunately. its cheaper than forking out for tyres all the time because of excessive wear! think of it that way
Ahh my bad didnt know. I know what your saying karl but its still a bit unfair imo. Isnt negative camber good for handling or by lowering are you passing that peak point. The tyre wear doesnt bother me if it handles better?? Sorry to high jack
Dont know what these are like but a bit cheaper AUDI S3 ADJUSTABLE TIE BARS FITS AUDI A3 S3 TT R32 QUATTRO | eBay
Dont know what these are like but a bit cheaper AUDI S3 ADJUSTABLE TIE BARS FITS AUDI A3 S3 TT R32 QUATTRO | eBay
Not in this case no... neg camber on the front works due to the way the suspension loads up on turn in so you roll on to the tread area getting more grip... this is less relevant on the rear as the effect is less so with more neg camber on the rear the less full tread area you get on the road...
General rule of thumb is to dial the rears to -1deg camber which can only be done with adjustable tie bars...
Most of the manufacturers of these parts are European and as such need to acquire TUV approval which would no doubt bump the price up on a part thats not got a massive market...
<tuffty/>
can these be sourced anywere cheap?
i dont fancy paying £200+ with bushes..
How low can I go before rear neg camber gets too excessive? I will be replacing rear tie arms when I can source some but will be fitting my coilovers on Tuesday. Will a 50ish mm drop be ok to run for a few weeks or so?
Can I detach the rear tie arms without touching the springs and shocks?
Overall length of tie barThanks!
Is that the total length of the bar?
Maybe if there is enough interest....we can get s3dave to run another batch at a more affordable price? I know i could do with some of these but i don't want to make the mistake of using cheap spurious parts. Come on Dave, help us lads out
Maybe if there is enough interest....we can get s3dave to run another batch at a more affordable price? I know i could do with some of these but i don't want to make the mistake of using cheap spurious parts. Come on Dave, help us lads out