Wishbone rear bushes

[SiGainey]

Planning a big suspension overhall soon - got new rear arms and bushes and was planning on doing top mounts and wishbones at the same time.

I was going to replace the rear bush in the front wishbone with the TT none-voided bushes but dont know if these can be pushed in without the use of a press. Anyone know?

 

[Welly]

I would recommend pressing them, however I did fit a set once using a bench vice....

 

[Syvo]

oxyacetaline or how ever you spell it, i burnt mine out and pushed the new ones in using a vice, i used powerflex bushes as they were two piece bushes so nice an easy to fit

 

[superkarl]

Vice will work, just hard to get it straight. Which is important as the top side needs to sit flush with the wishbone

 

[Welly]

Which is important as the top side needs to sit flush with the wishbone

Very good point.

 

[SiGainey]

Thanks all. Press it is then. Will remove them DIY and cycle them to the local garage to press in