Hi all,
Managed to remove all my valves from the cylinder head.. One of the intake valves was stuck at the top of the guide, I managed to tap the valve out but I dented the top of the guide a bit and the valve took a layer off the id of the guide? I plan to get this guide replaced but the valve in question is too wide around the groves to fit a new guide, not quite sure what to do?
Any advise would be appreciated, thanks.
Managed to remove all my valves from the cylinder head.. One of the intake valves was stuck at the top of the guide, I managed to tap the valve out but I dented the top of the guide a bit and the valve took a layer off the id of the guide? I plan to get this guide replaced but the valve in question is too wide around the groves to fit a new guide, not quite sure what to do?
Any advise would be appreciated, thanks.