Recommendation on big turbo build for S3

[Oneperformance]

hi,
I am not really studying hard on my car for big turbo build. I have a 3 door s3 with clutch upgraded and stage 2+ setup with tune. Currently I'm looking to install GTX 3076R with intension on RS6 injectors and forge piston(standard size). Just seeking for advise if any one had did or can share the setup with me for my reference.

Thanks

 

[S3Alex]

If you can bear it,have a read through my build thread.

I'm running the following on my car....

ITG intake
Ferrea valvetrain
PEC rods(you will need uprated rods if you get to anywhere above 440lbs)
Wossner pistons
Uprated bearings and shells.
ProAlloy intercooler
Owen Developments M-Spec GTX3582
Syvecs ECU with 8 injector setup
S3 injectors up to 400bhp,and extra port injectors above that
WMI

You would need to be looking at...

Uprated rods,bearing and shells
Uprated pistons
Uprated intercooler
WMI
RS4 fuel pressure relief valve
Uprated LPFP
A further uprated clutch

It may be better to start by asking how much power and torque you want ,and how big your budget is.

The TTE hybrids will get you into the low/mid 400s,and the APR Stg3 kit will take you a little further,without the expenses of engine rebuilds and custom manifolds etc.

You should only be looking at more if you really are set on the 500s.

Once you get into that sort of range it does begin to get very expensive.

If that's what you're after,I can point you to all of the right people.

 

[S3Alex]

hi,
I am not really studying hard on my car for big turbo build. I have a 3 door s3 with clutch upgraded and stage 2+ setup with tune. Currently I'm looking to install GTX 3076R with intension on RS6 injectors and forge piston(standard size). Just seeking for advise if any one had did or can share the setup with me for my reference.

Thanks

Any thoughts?