I´m owner of a Audi A3 LM 8V 2014. Recently, i installed a front and rear sensors with full kit: wire harness, buzzers, module and everything is in place. My local master did the flush mount sensors, as the pictures below.
My local master has the Audi software and the parking sensor module (8K parkhilfe) was detected by the software (picture attached), what it shows that the wiring was connected perfectly. However, he can´t codding the module because he has to be on line with Audi database and he cant do it (he is not an authorized dealer).
1) can i do the module coding with VCDS software? Wich version will works?
2) Wich steps i should follow to do it correctly, with the all bits codding and OPS on the MMI, front and rear?
Thx a lot!