Need pics of LHS of 3.0TDI (BKN) engine bay

OliNix

Registered User
Joined
Nov 5, 2014
Messages
442
Reaction score
143
Points
43
Location
London, United Kingdom
When I took my engine out I have a lot of pics of the RHS (as you look out of the car) but not the LHS. I have a rogue vacuum hose and need to work out the routing for the radiator coolant top hose.

Can someone remove the cover off of their engine and take a picture similar to below but for the other side. A few pics of the whole lot would be even more helpful!

Before someone says yes I have googled it, I need specifically this engine in this chassis though, an A4 B7 3.0TDI (BKN).

c411314cefe3e3fe2d0b91b1071f5005.jpg


3f4d77414528adba236f97272648d11f.jpg
 
Any good?
IMG 20180709 194910410
IMG 20180709 194917266
IMG 20180709 194927285
 

Attachments

  • IMG_20180709_194910410.jpg
    IMG_20180709_194910410.jpg
    759.8 KB · Views: 231
  • IMG_20180709_194917266.jpg
    IMG_20180709_194917266.jpg
    800.5 KB · Views: 224
  • IMG_20180709_194927285.jpg
    IMG_20180709_194927285.jpg
    796.3 KB · Views: 250
It appears to go to the bottom of a hydraulic reservoir.
In the photo I am trying to touch it with my fingertip but itsi hard to see.
IMG 20180710 080042800
 
I just double checked to make sure I was following the pipe indicated in your photo.
It is definitely diving down under the P/S res. After that I can't tell.
 
Had a chat to Audi today when I picked up some o-rings. Apparently it goes to a vacuum reservoir. So I presume this is in the wing somewhere. Thanks for your help.
 
I did notice the pipe is joined just before it disappears. So you might have a short pipe coming through the inner wing perhaps.