Miltek rear box outlet pipe dia info required.

[Charlie Farley]

Evening chaps.
Just a nice easy one for a change, can anyone advise on the rear silencer outlet pipe diameter on the miltek tfsi exhaust system.
I'm about to order a resonated system which is supplied with 100mm jet tips which i wont fit, but will transfer over my custom quads but need to know the tube diameter to ensure my quads will fit ok .

any info would be greatfully recieved.

rob

 

[Charlie Farley]

I'm open to a vgc used one if such a beast exists .

 

[Sygh2k]

without removing, mine it looks to be 2.1/4"

 

[Charlie Farley]

Thanks chap.

 

[norad97]

I have a Milltek exhaust, do you want me to measure the back box outlet dia?

 

[Charlie Farley]

That would be good Richard just in case of any variation in pipe spec from miltek.
With sygh2k info and yours that will be great, very much a case of measure twice to be super sure.

cheers chaps.

 

[norad97]

Ok I will get the Vernier caliper on it tomorrow.

 

[Charlie Farley]

 

[norad97]

The best I could get is 2.126 in, as it's difficult to measure, as there is a very small gap between the tip end and the back box,
I would say 2.1/4 would be about right, as I was laying on the floor under the car.
Funny I thought it was 2.1/2in system, measured the pipe back from the back box and seemed to be 3in.
So confusing?