Injector seat change

[QuestMS]

Sorry if this has been covered already but I couldn't find the answers I needed...

I have new injector seats to go in an inlet manifold I just had aqua blasted, I need to know what sealant I should use when fitting. I have some of the Mac tools threadlocker which is oil tolerant but not sure if its the right stuff for the job.

What thread locker or sealant have people used when replacing these injector seats?

Thanks in advance

J

 

[<tuffty/>]

I have used silicon sealant on mine... little bit in the threads and all good..

<tuffty/>

 

[QuestMS]

Cheers buddy