Found a pretty big boost leak on the LCR today

G

gokiwi64

Guest
Basically the T.I.P wasn't on the compressor housing at all well :), The thing is it doesnt seem to want to stay on there either.
The compressor housing has a step in in it , should the T.I.P fit over this step or just on the very narrow first part ?.

MD212-6.jpg
 

-Ju-

Well-Known Member
VCDS Map User
From my LCR days I would say the tip should go all the way on and the jubilee clip will tighten into the groove.
I had a few issues with it coming off if the connection was a little oiled up so make sure its clean
 

-Ju-

Well-Known Member
VCDS Map User
Make sure its a decent clip too, one without sharp edges as it can cut into the silicone if you have one of those fitted
 
Top