Fitting Cupra r splitter

[ZedS4]

Hi all
anybody know how to modify the Cupra r splitter to fit s4 bumper?
I under stand you need to saw down the front two bits but do I need to flush it or keep it in line with sides?
And best way to fit?
Im guessing rivet gun?
Thanks
zahir

 

[S3 JOHN]

Hope this helps , its on my s3 but the process is the same . I drilled and bolted mine rather then using self tappers .
In regards to trimming the middle posts down just cut then try it on and keep trimming to suit . Took me a little time to get it sitting level. But some people do leave them long to give the pouting look .
Also i used a heat gun to bend the ends so it follows the line of the bumper .
Best of luck .

 

[ZedS4]

Thanks John
Il give it a try when the bumpers of for the cambelt

 

[audimad100]

easy job, you will need to cut the 2 no center bars down about 20mm, i would use masking tape to give you some guide lines to work to. i fixed mine with Tech screws and adhesive. once its fitted you will need to trim both ends as they will be slightly to long