- Joined
- Jul 11, 2011
- Messages
- 1,860
- Reaction score
- 443
- Points
- 83
Not sure everyone's going to like this, but I thought I'd have a pop at making my own poly-bushed rear diff carrier...
I had a bit of poly-tek left over from doing the engine mounts on my A3 and went about hatching a plan of attack for the diff carrier. Without going into too much detail just yet, here's how the first one turned out.
I thought it was on the **** at first, but I think it's just the way the mould sat making it look ******. I've checked and it seems straight initially. I suppose the proof will be in the fitting but maybe I'll try a more accurate means of measurement prior to fitting.
Still got the other side to do, so more to come. Just thought I'd show you guys how it's turned out so far, and would be interested to hear your thoughts!?
I had a bit of poly-tek left over from doing the engine mounts on my A3 and went about hatching a plan of attack for the diff carrier. Without going into too much detail just yet, here's how the first one turned out.
I thought it was on the **** at first, but I think it's just the way the mould sat making it look ******. I've checked and it seems straight initially. I suppose the proof will be in the fitting but maybe I'll try a more accurate means of measurement prior to fitting.
Still got the other side to do, so more to come. Just thought I'd show you guys how it's turned out so far, and would be interested to hear your thoughts!?