Elsawin - lift point bung

[Dunedin]

Hi all,

Is there anyone with access to elsawin that could send me the pages relating to fitting the bungs for lifting an 8v on a 2 post ramp.

I am trying to identify the bung I require and how to fit and remove them, I’ve read a lot of posts relating to jacking the car up however I can’t find any inf on these.

Thanks in advance.

 

[Harvey]

I believe these fit all 8V models but please double check with someone who can cross ref against your VIN.
8V0802847A for the rear, this fits left or right click me.
8V0802845 for front left click me.
8V0802846 for front right click me.

Can anyone else confirm the above numbers fit all 8V?

 

[Dunedin]

I have these fitted however I think they are popped out and a rubber bung inserted to allow the vehicle to be lifted.

 

[8YARWY]

Item 23.

Sent from my iPhone using Tapatalk

 

[Dunedin]

Thanks for the replies. Does anyone have these?

 

[8YARWY]

Thanks for the replies. Does anyone have these?

I believe this part clips into the hole under your plastic cover......


https://www.ebay.co.uk/itm/AUDI-A3-...te-Front-8V0804631B-NEW-GENUINE-/382719141286

 

[8YARWY]

You can also lift the car from the 4 cill points too, but you'll still need a rubber insert/puck of some type to protect the cills.

 

[8YARWY]

I have these fitted however I think they are popped out and a rubber bung inserted to allow the vehicle to be lifted.

View attachment 208926

They are just a plastic cover for the holes in the bodywork.

 

[Dunedin]

You can also lift the car from the 4 cill points too, but you'll still need a rubber insert/puck of some type to protect the cills.

Thanks, yes I have a puck for lifting each corner.

 

[Dunedin]

They are just a plastic cover for the holes in the bodywork.

I was going to remove one to have a look to see if there was any rubber mountings underneath.

I seen this video



And I’ve seen another were the car is lifted with the cover still inside the bung.

It’s not clear the best way to go