Daytona Grey C7 A6 Avant.. small mods

[SPek9]

I have been on this forum for a while and previously owned a B7 A4 Avant Quattro, k04 modified to 320hp

This is the replacement and is a low mileage 2013 Daytona Grey C7 A6 Avant, great car with more comfort than the A4 just not quite as fun to drive

 

[r15wne]

very nice..
i dont suppose you have part no for splash gaurds , i enquired at audi for c7 2014 sline and was told they didnt do them,
also ive looked at some others but they clearly state for se spec only and dont fit sline models upto 2014,
2015 sline are available at audi but nothing for 2011-2014 sline,
just been getting some mixed information..
thanks

 

[Rhyso]

They don’t do mudguards for S Line models for the pre-facelift version

 

[r15wne]

mine is the same sline a6 as member Spek9 he has them on in the pictures, that's what im after.

 

[Rhyso]

mine is the same sline a6 as member Spek9 he has them on in the pictures, that's what im after.

Perhaps he has modified them to make them fit?

 

[SPek9]

They don’t do mudguards for S Line models for the pre-facelift version

very nice..
i dont suppose you have part no for splash gaurds , i enquired at audi for c7 2014 sline and was told they didnt do them,
also ive looked at some others but they clearly state for se spec only and dont fit sline models upto 2014,
2015 sline are available at audi but nothing for 2011-2014 sline,
just been getting some mixed information..
thanks

Your right, Audi didn't seem to make mudflaps for the Prefacelift S-Line. The facelift mudflaps fit but there is a gap between the outside edge of the skirt and the mudflaps, so what I did was test fit the mudflap and used some tape to mark and close off the gap left.

With the shape that I needed for the mudflap I used a black casting resin and poured it into the mudflap to mould it into the shape that I needed. The good thing was that the masking tape that I used left a grain on the outside of the new moulded portion that is very close to OEM

 

[SPek9]

This is what I used, after the mould is finished it is possible to pop the moulded shape out of the mudflap.. it shouldn't be a problem as the skirt will hold it in place but I glued it back down just to keep it tight



http://www.mbfg.co.uk/polyurethane-casting-resin/polycraft-fc-3680-black-polyurethane.html

 

[Rhyso]

So just to clarify you bought the face lift S Line mudflaps??

Love Daytona Grey by the way; not a massive fan of the wheels if I'm honest though

 

[SPek9]

So just to clarify you bought the face lift S Line mudflaps??

Love Daytona Grey by the way; not a massive fan of the wheels if I'm honest though

Yes they are genuine facelift S-line moulded mudflaps



Each to their own I suppose, what sort of wheels do you have on your A6?