Ctek CT5 Start Stop Battery Charger & I also bought an extension cable which fits into the cable direct, to route around spare wheel well then up to side storage pod. When finished with Charger I just pop cable into the cubby hole complete with plug and pull out rubber connection to charger which goes to battery.
I was initially going to put in the bonnet area until I found the croc clips are not suitable but already had bought a rubber cover for the charger to prevent scratches to the paint but comes in handy in boot to secure charger with a cable tie with cover fitted.
These charger do get warm when on fast charge ( asked CTEK about it as thought it was strange ) but they said it was normal so when charging I leave cubby hole open for ventilation.
Oh forgot to mention in the other post - the negative cable for the charger ( ring connector which is in the box ) I found the boot floor has a few screwed studs fitted to the body of no obvious use, but a 10mm nut fitted the thread plus ring connection went over stud so grounded to body - quite easy.
I didn't even have to disconnect the battery as the +ve clamp for the battery has a 10 mm nut, so just un screwed it and fitted ring connector with clamp in place and back on with nut.
View attachment 200214
View attachment 200213