Ashtray/coin holder upgrade

Keef

Registered User
well after slumming it for the last 3 years, I've finally got round to getting the posh Audi one, instead of the Seat one I've had for a while. Not a bad deal, £10 from eBay, looks like a driving school are selling a job lot of them after removing from new cars.
image.jpg
I
 

Keef

Registered User
Nice work guys, I didn't even see the make offer box! Ah well only a couple of quid.
Just a word of warning, postage rate is fair, but was only wrapped in an A4 envelope, mine survived the journey but a little bit of bubble wrap wouldn't have gone a miss.
 

GeoffDunk

Registered User
Large one FOC with new car, small one £10 on fleabay.
IMG_4256.JPG
 

Bristle Hound

Moderator
Staff member
Moderator
PS Forgot to mention. Mine arrived too
Considering it was only posted in a A4 size paper envelope I'm amazed it never got damaged in the post
Mine came with a new OEM Audi A3 ciggy lighter too
Nice one @Keef
 

Point_Audi

Vorsprung durch Technik
Staff member
Moderator
VCDS Map User
Mine arrived today also, thanks for the link @Keef .

Funny @Bristle Hound I wondered what the rattle was and that’s when I found the cigarette lighter also, always nice to get something free!lol
 

ross27

Registered User
I also got mine on Tuesday.

Dont know about you guys, but when i push it right into the cup holder, the lid doesnt close properly and rests on the centre console plastic.

I think it would work better with a 10mm spacer underneath.

Dont get me wrong, it is fine as it stands, but id fear that it would mark the plastic over time.
 

JG51 AUD

Registered User

JG51 AUD

Registered User
Just got another one of these for a mate, £6.70 accepted. :yes:
JG
 

Point_Audi

Vorsprung durch Technik
Staff member
Moderator
VCDS Map User
Fantastic find, very handy!:) I have purchased two from this seller, one for a mate and an extra one for holding change on my desk!:tearsofjoy:
 

TerryA

Registered User
I also got mine on Tuesday.

Dont know about you guys, but when i push it right into the cup holder, the lid doesnt close properly and rests on the centre console plastic.

I think it would work better with a 10mm spacer underneath.

Dont get me wrong, it is fine as it stands, but id fear that it would mark the plastic over time.

spin it 180 degrees then it is OK
 

X_Splinter

Registered User
I found this part number: 8UD 857 951 but not sure if it the big one or the smaller
 
Top