Anyone running Forge catch can, help needed...

[lucky_bob]

Hi, just finished installing forge catch can, n noticed little gap in top left corner, with eye i can c the orange seal phone don't pick that up, is it safe to run??? oem plate has an edge on but forge is flush thats why i guess i got little gap??? many thx

 

[lucky_bob]

update, managed to figure out the problem, nothing wrong with forge parts, its my plastic valve cover it ain't straight where pcv connects leaving a gap , ordered new cover will c if that one sorts out the problem, still would be nice to here from someone running forge catch can, did u had any issues, thx

 

[Muzza80]

Not uncommon mate, I noticed a similar deformation on that area when fitting a PCV revamp kit, mine was only slight.

The plastic deforms with the heat I think.

 

[lucky_bob]

will c tomorrow, new cover will be at audi waiting, hope it will be straight