Load reduction relay location and number

Hongu123

Registered User
Joined
Jan 30, 2020
Messages
3
Reaction score
0
Points
1
Location
Yorkshire
Hi I have searched (a lot) for the location of the load reduction relay on my Audi A4 2002 2.0 saloon

Can anyone point me to diagram that shows it?
Mine only has 4 relays under the dash.

From what I can see the number of the relay is 18
I don't have a no.18 relay under the dash.

The problem is my Horn, wipers, windows, indicators and cigarette lighter have all stopped working.
When I start the car the lights, cig lighter ect. don't do out, which I though was the function of this relay.

Please help.

P.
 
Never heard of that relay. I would of thought the CCM (Central Convenience Module) has failed.
 
Yep as above, sounds like you need a scan to see if you can communicate
 
Thanks for the replies guys.

So it had a scan and can't communicate with the CCM.

I have replaced it with another one and still can't communicate.

Any ideas where to look next?

Cheers

P
 
To add to this now!

I have fitted a new ccm, a new power control module.
Checked the wires in the drivers door boor for broken wires.
All to no avail.

I then noticed a thin white and blue wire broken in the loom in the drives footwell.

I can't find where it has come from.

Does anyone know where this white and blue wire goes to?
It comes from the top part of the harness.

I can read wiring diagrams a bit but don't have the expert knowledge to trace it.

Thanks in advance.

Phill
 
To add to this now!

I have fitted a new ccm, a new power control module.
Checked the wires in the drivers door boor for broken wires.
All to no avail.

I then noticed a thin white and blue wire broken in the loom in the drives footwell.

I can't find where it has come from.

Does anyone know where this white and blue wire goes to?
It comes from the top part of the harness.

I can read wiring diagrams a bit but don't have the expert knowledge to trace it.

Thanks in advance.

Phill
Hello


Did you find a solution to this? I have the same fault and i am going around in circles!

Thanks in advance