2008 A4 Fault Codes help

5pot

Favouritism
Joined
Sep 27, 2011
Messages
805
Reaction score
1,239
Points
93
Could someone please tell me what these fault codes mean

Address 01: Engine (J623-CAGA) Labels: 03L-906-022-CAG.clb
Part No SW: 03L 906 022 JN HW: 03L 906 022 B
Component: R4 2,0L EDC H01 3174
Revision: 11H01---
Coding: 0104002C02072118
Shop #: WSC 00847 210 91033
ASAM Dataset: EV_ECM20TDI03L906022JN A01004
ROD: EV_ECM20TDI03L906022JN.rod
VCID: 7AF0890AFDC4789


1 Fault Found:
5293 - Throttle Valve Actuator Module (J338): Motor Circuit
P2103 00 [032] - Signal High
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 18


Address 02: Auto Trans (J217) Labels: 0AW-927-156.clb
Part No SW: 8K0 927 155 AF HW: 0AW 927 156 G
Component: 0AW 20TDI RdW H01 0006
Revision: --H01--- Serial number: 0000000157
Coding: 000001
Shop #: WSC 06325 000 00000
ASAM Dataset: EV_TCMVL381 A02005
ROD: EV_TCMVL381_AU48.rod
VCID: 77F6903ECED6651


1 Fault Found:
2225 - RPM Signal from ECU
P0727 00 [096] - No Signal
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 01100000
Fault Priority: 0
Fault Frequency: 0
Reset counter: 0

Address 03: ABS Brakes (J104) Labels: 8K0-907-379.clb
Part No SW: 8K0 907 379 AA HW: 8K0 907 379 AA
Component: ESP8 front H04 0060
Revision: -------- Serial number: --------------
Coding: 170500
Shop #: WSC 06325 000 00000
VCID: 78F49302CBC86A9


1 Fault Found:
00473 - Control Module for Elect. Park/Hand Brake (J540)
013 - Check DTC Memory - Intermittent
Freeze Frame:
Fault Status: 00101101
Fault Priority: 6
Fault Frequency: 1
Reset counter: 71

Address 05: Acc/Start Auth. (J393) Labels: 8K0-907-064-05.clb
Part No SW: 8K0 907 064 C HW: 8K0 907 064 C
Component: BCM2 1.1 H70 0134
Revision: 00002001
Coding: 011100
Shop #: WSC 06325 000 00000
VCID: 30646B226338729


Subsystem 1 - Part No SW: 8T0 959 754 D HW: 8T0 959 754 D
Component: FBSAUDIB8 IDG H37 0060


Subsystem 2 - Part No SW: 8K0 905 852 D HW: 8K0 905 852 D
Component: ELVAUDIB8 H36 0041


1 Fault Found:
00956 - Key 2
005 - No or Incorrect Basic Setting / Adaptation - Intermittent
Freeze Frame:
Fault Status: 00100101
Fault Priority: 3
Fault Frequency: 17
Reset counter: 84




The car is a 58 2.0tdi A4 Sline. The engine check light is on and a coil-preheater? light is flashing. I had the egr and throttle body cleaned but the lights are still on the dash.
The car runs fine and hasn't gone into limp mode. Appreciate any help :)
 
Last edited:
Clear the faults and see if they come back.
 
5293 - Throttle Valve Actuator Module (J338): Motor Circuit
P2103 00 [032] - Signal High

Any luck with this fault?
I have same car, same year and same fault!
I too had the flashing coil light and Engine light, but never went to limp mode.
I also cleaned the throttle valve and then replaced it with a second hane one,but still the fault code.
 
These are the only codes I could find anything on............................

[h=2]00473 - Control Module for Elect. Park/Hand Brake (J540)[/h] [h=3]00473 - Control Module for Elect. Park/Hand Brake (J540): No Signal/Communication[/h] [h=4]Possible Causes[/h]
  • Wiring/Connector(s) from/to Control Module for Elect. Park/Hand Brake (J540) faulty
  • Fault(s) stored in Control Module for Elect. Park/Hand Brake (J540)
[h=4]Possible Solutions[/h]
  • Check Wiring/Connector(s) from/to Control Module for Elect. Park/Hand Brake (J540)
  • Check Measuring Value Blocks (MVB)
    • Usually Measuring Value Blocks (MVB) 125+ show the current Communication Status


[h=2]00956 - Key 2[/h] [h=3]00956 - Key 2: Adaptation Limit Surpassed[/h] [h=4]Possible Symptoms[/h]
  • Remote control not working.
[h=4]Possible Causes[/h]
  • Key not matched.
  • Key operated more than 200 times while out of range.
[h=4]Possible Solutions[/h] See vehicle specific page for synchronisation/adaptation procedures.
 
5293 - Throttle Valve Actuator Module (J338): Motor Circuit
P2103 00 [032] - Signal High

Any luck with this fault?
I have same car, same year and same fault!
I too had the flashing coil light and Engine light, but never went to limp mode.
I also cleaned the throttle valve and then replaced it with a second hane one,but still the fault code.

Yeah, I replaced the throttle body with a brand new one and cleared the faults. No problems since :thumbsup:
 
Clad to here its all good now.:thumbsup:
 
Yeah, I replaced the throttle body with a brand new one and cleared the faults. No problems since :thumbsup:


I've now done the same, new part and cleared faults, all seems to be ok now - no warning lights!