pdc

  1. audi8y2021

    Manual for retrofitting PDC Front

    Hi all, Got my hands on a set PDC Front including module and cables via AlieExpress. I thought there would be a wiring diagram or manual on how to install. Recently I installed a rear view camera myself and if I did not had the manual I never would have succeeded. So any help is welcome! P.s...
  2. N

    Parking sensor retrofit

    Hi, I have a 2016 (66) A3 8V. I have purchased a parking sensor kit which came with all the modules etc however i am unsure where to connect the cables. I have attached pictures. Any help would be appreciated. Thanks
  3. G

    Audi A3 8V Front Parking Sensor Speaker Location

    Hi, I need to replace the speaker for the front parking sensors on my 2014 Audi A3 Saloon. The front sensors have stopped working and I am getting no sound when I try to adjust the volume for them so I assume it is a faulty speaker. Could someone provide with the location of the speaker? The...
  4. S

    AUDI A3 8V Parking sensors retrofit guide (8k Front + Rear)

    Hi all, I recently retrofited front and rear OEM parking sensors into a 2015 PFL audi A3 8V saloon and since this forums have helped me so much, I wanted to share my 2 cents by creating a retrofit guide, hopefully someone will find it useful: I've seen that many people (including myself) have...
    • swuw231
    • Thread
    • parking display ops front parking sensors parking sensors front and rear retrofit pdc sensors
    • Replies: 101
    • Forum: A3/S3 (8V Chassis)
  5. A

    Front bumper parking senors

    Hi guys, My 2015 s3 saloon had a front end bump, so i bought a used front bumper off ebay. However like an idiot i did not reaslise the bumper does not have the cut outs for pdc and my car is equipped with front and rear pdc. Question is, is it just a matter of cutting out holes or do the...
  6. D

    Cutting holes in bumper for headlight washers

    Hello I after a small accident, I've managed to source a new front bumper for my A6 Avant. Only problem is that my A6 has headlight washers, but the new bumper does not have the cut outs for it. Is it possible to cut the holes myself? And is there a template? Or will I have to get a new bumper...
Top
Back