pcv

  1. S

    Help 2016 PFL RS3 PCV/ Separator?

    Hey, Can someone please help with Idle hunting and crankcase suction and whistle? It's a 2016 RS3 PFL. I have already replaced the Diaphragm, cap and spring. Where else should i be looking?? Seems really hard to find any engine diagrams online to locate oil separator etc. any help would be...
  2. Baawlz

    Audi A3 8V - Valve Cover Gasket and Cam Cover Gasket Replacement DIY

    Hello, New to this forum but I need help. Currently in the process of doing my valve cover gasket and my cam cover gasket do to a failing PCV cause abnormal crankcase pressure and blowing out my seals. Basically got almost everything pulled out, just a couple bolt left to remove + fully...
    • Baawlz
    • Thread
    • a3 8v audi 2.0 tfsi ea888 mqb gen 3 pcv s3 8v valve cover
    • Replies: 1
    • Forum: A3/S3 (8V Chassis)
  3. W

    Clear liquid leaking from under my car

    Hey guys, I've noticed a small clear puddle that forms under my car after it has sat in the garage for 1/2+ days. I don't believe its from the A/C as it has a somewhat oily feel to it and dries almost crusty white. If this helps; I've been experiencing somewhat rough idling, noticed a slight...
  4. A

    Dipstick affecting idle and DV solenoid issue

    I have been experiencing an underboost issue , so today i replaced the dv (reg G) with rev D. Yes a down grade, however I didn't know what was on my car. On a side not, the solenoid on the DV valve was the issue, the seals and gasket looked brand new, however with ODB11 I couldn't make the...
  5. curlo

    Uprated PCV breather hoses

    Hey all. Is anyone aware of any aftermarket breather hoses designed to be used with the OEM PCV in the EA888.1 engine? I'm looking to replace the nasty corrugated front and rear breather hoses on my 8P 2.0 TFSI (CCZA engine, also found in the Mk6 GTI). ECS do an upgraded kit for the 8V/Mk7...
Top
Back