manifold

Right, well out the loop as I haven't owned a K04 car for nearly 12 years. I'm sticking a BAM in my Mk2 Golf and I'm after some parts. The engine I have sourced has a cracked standard turbo, so I figure why replace when you can upgrade. Looking for the following... - Tubular exhaust manifold...

Hi all! Hope our christmases and new years were good.. anyway on to my problem. I have an s3 with a BAM engine (although AGU head) and iv been having an overboost issue since i owned the car, but having trouble trying to solve it. I can keep the boost at actuator pressure by running a direct...

Hello everyone. So last week I've bought a used a4 b8 3.0 tdi (240hp) manual quattro. It's a 2008 model with 230000km on the clock. The hood and front mask have a few stone chips but nothing major and not very noticeable. The chassis is from S line so its 3cm lower from the factory. It also...

I believe it should fit many different VAG cars. However you need to do your own research for fitment to your vehicle. Manufacturer Part Number: 06F145701H ; 06F145701G ; 06F145701D ; 06F145701E ; K03-0105 Part Manufacturer Number: rs9848598484 Reference OE/OEM Number: 53039700086 ...

Hi guys, I had been experiencing slight loss in power recently on my A4 B7 2.0Tdi, booked in the car with the local garage and they said the diaphragm on the intake manifold (or whatever) was broken. How the fock did this happen, I have no clue - pics below FYI: (is this the diaphragm, right?)...

Got my hands on 2260vk for 2.0 BKD 16V now, manifolds found potential candidates one from Xman’s Turbos short manifold and darkside finest tubular. I use my car daily therefore need it to spool quicker over max power, only aming for 240-260. What and why Thanks

Hello everyone can anyone help me? Recently purchased my first car 3 weeks ago Audi A3 2.0 tdi 54 reg everything seemed fine when I test drove and everything was going fine until about a week later engine management light came on then went into limp mode plugged it in and came back as inlet...