glass
-
Drivers window
So my drivers window goes down fine, but putting it up the window gets stuck around 50% of the way up. Check the rubber channels and can't see any obstructions but it looks as if the glass is pointing too far towards the centre of the car so it is becoming too tight to the rubber seals. I'm...- calw123
- Thread
- driver side driver window sportback glass s3 8v stuck trapped window
- Replies: 5
- Forum: A3/S3 (8V Chassis)
-
R
Rear windscreen shattered
Hi everyone, I got a s3 8y saloon, only had it for 2 months and my rear windscreen shattered when I put my heated screen on while I was driving. After it shattered there was an electrical burning smell coming for right hand side c pillar (I’m guessing the connector is there). I already have the...- Ricky0610
- Thread
- advice audis3 audis38y glass heated rear window s38y s3saloon saloon turboblue
- Replies: 1
- Forum: A3/S3 (8Y Chassis)
-
J
Audi a3 2014 wheels
Hi, I am about to buy this car, i was wondering if the wheels are modified (want to avoid it due to insurance) it may be the case of having totally different wheels or them being painted as well as the tinted windows. If you you cannot answer it, who do I ask? I asked the dealership and they...- JAudi321
- Thread
- glass wheels
- Replies: 57
- Forum: A3/S3 (8V Chassis)
-
P
Alarm fault - glass breakage sensors
Hi, my alarm keeps going off at random times when locked. Only the lights flash as I’ve already disconnected the siren from the alarm module in the lower rear right of the boot. Every time I scan it, VCDS says it’s the glass breakage sensor in the right rear side window - G184. I read that...- p-rossi
- Thread
- alarm breakage g183 g184 g303 glass
- Replies: 5
- Forum: Audi S4/A4/A4 Cab (B7 Chassis)
-
F
Wiper judder after GTechniq glass treatment
Hi folks, So my new car - less than 600miles. Wipers are new and there was no judder at all before treatment. Products purchased from Slim's detailing. I did the following. 1. With a very clean windscreen I polished the glass with G4 and new microfibre cloth and then removed the residue...