error

  1. Widg

    A solution for replacing foot well and boot bulbs with LED - CANbus error

    Faffing today to repair some of the previous owners' attempts at chaving up my car. Problem - The foot well lights and boot light not working. No power to either circuits, fuses OK, needed to reset error codes to get power back to circuits. Now got power for about 2 seconds. After repairing...
  2. Nath94

    P2563 error code! Help!

    Hi everyone, I was having a problem with my turbo. I had a error code saying ‘ actuator stuck ‘ and I also had code P2563 - turbocharger boost control position sensor circuit - implausible signal. So, I put a new/remanufactured turbo from AET turbos on my car yesterday which got rid of the...
  3. A

    AUDI A3 CRUISE CONTROL - ERROR 22 CODING HELP!!

    Hey guys. I've just retrofitted the MFSW and CC to my Audi A3 8p Quattro late 2005. The steering wheel buttons works fine however the cruise control is being a pain! I get the following error: logincode not accepted by controller! You will have to turn ignition off before trying again. Error 22...
  4. X

    ECU, ESC, Hill hold, Parking break errors/faults

    During Easter i went to wash the car, and following the wash while i was finishing some minor detailing while the car was idle, the engine turned off and started showing errors: ESC Fault Hill Hold Assist: Unavailable Parking Break Fault (not every time though) When trying to turn on the...
  5. J

    Audi A4 1.4 Fuel Spraying

    Hi guys, Wish my Bluetooth issue was the only one. My one year old A4 is now stepping up her misbehaviour. I tried to start the car, it came up with an error. I clicked the START/STOP button again and the starter motor went for it, a few seconds longer than normal. Then a strong fuel smell...
  6. J

    Gearbox Malfunction: you may continue driving (S Tronic)

    I had this message and have not found this solution in my search of forums etc so I will share it. It started as intermittent, became permanent and then it started holding on to the key because it said it was not in Park. The gear indicator lighting also behaved erratically. Fault code was...
  7. H

    A3 8P - Do not exceed 4000RPM

    ALL! I keep receiving an error message on my Audi a3 black ed 1.8t 2010 Petrol It says do not exceed 4000rpm. However when i switch the car off and on it goes away. There is NO epc light when this comes on. Its happened on and off for about a year now. One thing that might be related i...
  8. T

    Camshaft over adjustment - long term

    Hello, so the other day, I found that my car was throwing up the DTC P0011. So my thoughts were that I had to change my chain link kit, so I bought a kit online. And unfortunately the bolt which connected it to the exhaust cam shaft; was busted so I had to replace the cam exhaust shaft aswell...
  9. S

    Hi, and A little help :)

    Hi everyone, so i finally managed to trade up my 08 vectra (which had a blown turbo and a mountain of ither problems!) and i took the plunge and brought an audi (finally). It's a 2014 a4 2.0 tdi 177 quattro s line. And i have to say i love the car.... However i ran a scan on the car and its...
  10. Jtg1998

    ESP/Boost troubles

    Got second hand 2008 A3 couple days ago. Started driving yesterday and felt very sluggish, so i took it up to higher revs and the glow plug light starts flashing. Took to garage and got code '00065 - Boost pressure regulator control range not reached'. Went to take it back to the garage today...
  11. Billy0123

    ESP & ABS lights illuminated and handbrake light flashing.. “Brake Fault”

    Hi all, Was looking for any sort of advice or direction. So, as described in the title, they’re the symptoms. Performance wise, it’s still running absolutely fine. I’ve not felt a change in power or the brakes. I took it to an auto-electrician for a scan, and it shown: “16352 - Control...
  12. V6_Man

    Help Please .First MOT, brake fluid change, warranty Checks and a remapped S4

    Folks, My B8.5 S4 is booked in tomorrow for her first MOT, brake fluid change and out-of-warranty checks. I ran a scan the other day using Carista and it showed one error re: ABS however, there is no warning on the DIS, at all. Below is the error that I got (and still showing after I cleared...
  13. A

    VCDS in Epsom or surrounding? Surrey/Hampshire

    Hi all, New member, hoping to get some help with clearing an airbag error light on a 2012 Audi A1. Made the mistake of running it with glovebox/airbag unplugged and having re-fitted glovebox realised the error isn't self cancelling :blink:. Trading the car in in 2 days and hoping someone...
  14. David Chambers

    Audi A3 1.4T turbo issues

    Hi guys, need a bit of advice, my car decided to not give me any power the other day, at first I thought my turbos gone, done a diagnostics, shows a few different things it could be, Solenoid valve P0243 Turbocharger bypass valve P0033 Purge control valve P0444 Camshaft A - position actuator...
  15. D

    "Error 31: Request out of range" in RLS submodule

    Hello! Sorry for my bad english. Skoda Superb 2012. I try to disable rain sensor in subblock "RLS" in block "9". The result is: "Error 31: Request out of range - Coding Rejected." --- At first I tried to set the values (in VCDS) the same as in this block of car: Imp: 790 WSC: 33361 Equipment...
  16. KrisKrk

    Fault or normal?

    Hi everyone, Got an issue with my A6 that is happening more often now. About 9-10 months ago, when stopped on traffic lights my car suddenly shook and revs bumped up by 100-150. Usually they about 800 when stationery and the car was warmed well enough as driven around 18miles. Moved off and...
  17. C

    CODING ISSUE WITH XENON HEADLIGHT CONVERSION *RETRO FIT* HELP!!

    ill explain a little , ive had these lights put in some of you might have seen my earlier posts but i got them in and the lights coded to work on low beams and the led strip to work as parking lights the man who coded it completely removed the option for DRLs on the infotainment system , its a...
  18. T

    No communication with CAN Gateway after RNS-E Coding Attempt

    Hey guys/girls, A friend has a 2010 A3 2.0 TDI Quattro and asked for my help coding in his recently fitted RNS-E. Unfortunately I've ticked a box or changed a number that has stopped the CAN Gateway working. Auto Scan no longer works, it just scans the CAN Gateway and tells me that there's no...
  19. Zak0123

    Air Bag Error - How to clear

    Afternoon all, I made the mistake of removing my glove box, unplugging the air bag and then turning on the ignition to test some circuits. Now I have the airbag error come up on my dash every time I start the car even though it's been reconnected. Can this be cleared without coding or will I...
  20. Cairnsy13

    Spot the difference...

    So I collected my new S3 on Friday, called my insurance yesterday to update my policy, hit a snag...can you see what the snag was? :whistle2: Before: After: If you missed it the dealer put plates belonging to a grey Q3 2.0tdi s-line on my S3. Caused a bit of confusion with the man from my...
Top