ecu & immobiliser

  1. Asahi

    Car starts then stalls [VCDS READOUT inc]

    Hi all, I'll keep it brief. Last week during this phase of bitterly cold weather my car wouldn't start. The car would start for a few seconds then stall and the glow plug light would constantly flash. I just assumed it was that and replaced all four glow plugs, some of which did measure high...
    • Asahi
    • Thread
    • ecu & immobiliser electrical fault glow plug light glow plug warning light glow plugs ignition non starter vcds
    • Replies: 5
    • Forum: A4/A4 cabriolet/S4 (B6 chassis)
  2. D

    A3 Ecu

    Hi I recently bought a 1.6 petrol non turbo 8p a3. However, I was unaware at the time that the car has been remapped very badly. The map is causing my emissions and engine management lights to show (they were taped over when I bought it) and is also making the car very uneconomical. I have...
  3. Mark 20vt 1994123

    Need help with ecu remap/immo delete

    Hello everyone I started a thread a couple of weeks ago due to car not starting I think iv narrowed it down to the ecu getting water damaged. The car is a audi a3 8l 1.8t Engine code- AGU Ecu code - 06A906018cj Took ecu out and opened it up. Was wet inside a lot of moisture and the circuit...
  4. ReggieB

    ECU & Immobiliser help needed - 2004 A3 1.6 FSI

    Hi Guys, 2004 A3 1.6 FSI Sport. I am having a problem where my car wont start without having to remove the battery terminal, then switch ignition to 1st click then connect the battery and then the car will start and drive as normal. Once you switch off the car you have to repeat the steps...
Top
Back