cylinder

  1. leon330

    A3 1.4 TFSI 150 COD cylinder mode noise (8V Phase1)

    Hi there, I see that I'm not the only one complaining about the unbearable noise of my car so I share my experience. Model: Audi A3 1.4 TFSI 8V 150 COD (Phase 1) (design 2016, purchase from Audi in early 2017, second buyer in 2022 with 40000 Km) Color Glacier White. Good general condition but...
  2. Rs3Life

    Cylinder on demand (c7 performance)

    Hi all, I'm new to rs6 and the cylinder on demand technology so I just want to check if all is good with the car or I should ask Audi to investigate the potential issue. Over the weekend I did 400 miles on highways and I was able to notice slight move or shake (similar to going over small...
    • Rs3Life
    • Thread
    • cylinder cylinder on demand rs6 rs6 c7
    • Replies: 7
    • Forum: RS6 Forum
  3. S3Jay

    Clutch pedal sticking intermittently

    Hi everyone I hope you're all well!. I am a new member to the forum and a new owner of an 8p Audi S3 Sportback as of last week. I'm really enjoying this car however I noticed a little blip a few times when driving. The clutch pedal sticks down briefly when changing gear. It also happened today...
  4. D

    misfire cylinder 2 - cant diagnose

    getting a misfire on cylinder 2 according to the last garage I took my car into (been to see 2 now), only they can not tell me what is causing it. Car has no MIL/fault lights on. I have recently changed spark plugs, spark plug leads and the coil pack. So I am not sure where to start on next as...
  5. P

    Car running only on 2 cylinders

    Hi guys, I have the following problem.. The car runs only on 2 cylinders.. The 1st and 2nd are not firing but the 3rd and 4th are. I have scanned the car and got the following codes: P0300 P0301 P0302 P0036 I have changed the spark plugs, and the coil packs AND bought the car a new 034motorsport...
Top
Back