3.0tdi quattro

  1. MadIrishMacs

    First Generation TDI V6 build (ASB Engine)

    Hey folks! So I'm new to the forum and to Audi specific ownership (I have owned several VW's over the years) and I thought I would create a thread for my planned build for my A4 Avant 3.0 TDI V6. I've owned the car since March 2022 and so far it has H&R lowering springs, a stage 1 remap running...
  2. John Nightingale

    Spinning glow plug

    Hello all, Great to meet you, I've just signed up after an unsuccessful attempt to change some glow plugs in the 3.0 TDI. 5 out of 6 have been successfully replaced (cheer) One plug (number 2 cylinder I believe) is freely spinning and will lift up and down by about 5mm. I've had a search...
  3. A

    A4 B9 3.0 TDI(272) Losing Water

    Hi all, hoping for a little help from the group if poss? I have a 2016 A4 3.0tdi which is losing water. Its been to both Audi and local specialist and issue not resolved. Its had a new thermostat, a valve between the v and a new rad pipe which I believe to have cracked due to a pressure...
  4. EricVR

    Audi a4 b7 3.0tdi glowplug issue

    Hi guys, New here I have a issue with my b7. Starts fine and drives fine. As soon as you need more power, the glow plug light starts flashing and I have a loss of power. Switch off and on, it's gone. I did a vcds scan, and it gave a glow plug fault on cylinder 2. I replaced the glow plug...
  5. J

    c7 - b8 avant 3.0 quattro??

    hello, I am obviously very new here i have been reading some articles but i haven't really found out what i am looking for, i was just looking for some advice over the c7 is a 3.0 quattro s tronic or the b8 is a 3.0 quattro manual, ive viewed the c7 yesterday and im on my way to view the b8 but...
  6. P

    Help Please A/C doesn't work

    Hi. As the title goes I'm having problems with air con. When holding the ac button the light is lit and turns off immediately upon releasing the button. On vcds it shows that the ac pressure is at 1.2bar. The pressure sensor looks good and does not appear to leak but I've noticed something that...
  7. P

    Prodigium's build

    Hello everyone. So last week I've bought a used a4 b8 3.0 tdi (240hp) manual quattro. It's a 2008 model with 230000km on the clock. The hood and front mask have a few stone chips but nothing major and not very noticeable. The chassis is from S line so its 3cm lower from the factory. It also...
  8. S

    Hello (2x Audi = 2x happiness)

    Hi, my name is David and I am happy owner of two Audi A6C6 avant and A4B8 saloon. Both TDI :))) I decided to join the forum after many years of reading it to help others and also to receive some advice - especially that my A4B8 3.0TDI CCWA which is running now on ~310/~700 (stock) is very close...
  9. Junc11Quattro

    Fresh Face!!

    Greetings to all of my Audi-sport.net family! New to the site! I own a beautiful Dolphin Grey B7 A4 Cabriolet 3.0 V6 TDI Quattro. (My Babes) hahahaha Done just over 90k, has every option and FSH. Drives like a dream. It's gonna be a small project over a while so hopefully you guys can stay...
  10. Sender

    Please help!! Audi A6 2012 3.0 biTDI

    Hi! I´m new on this forum and new in the audi world. Just bought myself a used Audi A6 late 2012 model engine code CGQB. Stock 313 HP and chipped to 380 HP I went to my family about 600 km from me and engine light came on and the glow plug light started flashing Now somehow I have to go back...
  11. Zako

    Cold start noise A4 B9 3.0tdi

    Hi, Looking for some advise from people to what they think this could possibly be or have experienced it themselves. On a cold start leaving the car over night when starting in the morning there’s a noise coming from what sounds like the back for the engine. The noise disappears when the...
  12. kitbennett

    A4 B7 3.0TDI Gentle Regen to fix the common the faults

    So my 2005 B7 Avant has clocked onto 126k this week. And I'll take that as an excuse to treat it to a few fresh parts. The car already sticks like glue to the road (Thanks partly to good Pirellis), but my aim is to refine the ride. Make it smoother yet handle the bends a little more square. I am...