Search results for query: *

First photo is the old unit, and second I'm fairly certain is the new unit box... mine's a brd but I'm confident it is a std part for many vag tdi's. Sent from my SM-G930F using Tapatalk

Just remembered I still have my old one in the garage. Will check the numbers in the morning if I get chance. Sent from my SM-G930F using Tapatalk

First bit of advice is don't use that garage if they suggest you need to change the inlet manifold! It is the inlet manifold flap actuator and can be bought from tps for about £15ish quid. Never seen one break like that though. Usually the diaphragm inside that perishes. You'll need to remove...

Crumbs that's a lot more rounded than mine was for similar mileage. How worn was the oil pump keyway? Sent from my SM-G930F using Tapatalk

Because failure is likely to be a new engine due to oil starvation. And that's probably why many A4 2.0 tdis are being broken.. I junked mine as the I had the front end of the car off for timing belt and dmf/clutch replacement. Glad i did. Sent from my SM-G930F using Tapatalk

I junked my balance shaft setup at 107k in favour of an ALH oil pump set up. So no future issues. My hex key wasn't badly worn but the amount of play to the oil pump drive was! Your welcome to come have a look at the unit if you want... I'm near Woking. Sent from my SM-G930F using Tapatalk

Have junked my balance shaft unit and pump at 106K the key wasn't bad wear wise but there was a lot of play between the oil pump and key. Now got an ALH set up. Sent from my SM-G930F using Tapatalk

Just swapped mine out for a non balance shaft setup using an ALH oil pump and chain drive. As you can see there is some wear but not masses. However there was a lot of play between the oil pump and key! This has done 106k miles and I'm glad I did it! Engine is more responsive and there's no...

I Had this same issue for a while, for me it was one of these three that cured it and I have just done them, now the car is much better and idled smoothly.; New dual mass flywheel and clutch (I think this was the culprit), Timing belt change and timing corrected, Oil pump and balance shaft...

I did... and I wasn't sure they understood what the difference between a quattro and fwd was!!! All they could do was run the reg number too.. Called Tps in the end and it appears the parts are the same and made by Luk. But there are clutch plate differences between 140 and 170 engines. Parts...

Ok so the euro carpets deal is now £314!! for the full Luk kit. 641442450-336440660 Can anyone confirm this is for the quattro too? Sent from my SM-G930F using Tapatalk

Ive Got an ecp deal coming out at £396. Which is decent. And there are deals as low as £340 on ebay Just need to know if the quattro is different.. Sent from my SM-G930F using Tapatalk

Bigger is always better in my experience... If you plan on remapping and tuning go for 3 inches all the way. Sent from my SM-G930F using Tapatalk

I'm going to do my clutch and DMF very soon too. Can anyone tell me the LUK part numbers? As I'm getting conflicting info and prices online! Mines a BRD Quattro. Sent from my SM-G930F using Tapatalk

Fingers crossed you're successful with the warranty. Just thinking, If the sump is off and engine open to weld the key.. Would it not be better to do the delete rather than spending more money taking the sump off again? Sent from my SM-G930F using Tapatalk

Yes the whole lot. The key wears as do the balance shaft and oil pump it connects between. Better safe than sorry two months later. Sent from my SM-G930F using Tapatalk

I Wouldn't bother. If you do upgrade, just buy a bigger turbo. Sent from my SM-G930F using Tapatalk

Be warned though if just the hex key is replaced it will very likely break again within a very short time period! make sure the whole assembly gets replaced. Sent from my SM-G930F using Tapatalk

Yes it is part of the oil pump and balance shaft assembly. The oil pump cannot be driven without it. Sent from my SM-G930F using Tapatalk

It's the piece that connects the balance shaft module to the oil pump. If that's worn you can guarantee the oil pump and balance shaft keyways are worn too. The lot will need replacing which isn't a small job. Google 2.0tdi balance shaft repair video and images and you'll see. I have just...