Search results for query: *

I haven't had it happen to an Audi, but i had a Saab 93 before and it completely died due to wiring to the ECU, no lights, no response at all from the car when that happened.

Absolute legend mate!!!! i'd been looking under the 2007 model parts base, which doesn't have anything listed - http://partscatalog.info/audi/en/?i=cat_vag_models&brand=au&number=1193&set=1204&ein=2007&f=412&hauptgr=1234567890&hg=8&grf=083760412&bf=83760&hgug=837&ug=37&parent_id=1300999 Just...

I've been hunting high and low for these and can't seem to get them anywhere, not even Audi have the part numbers!! Basically it's the screw that holds the window in place on the plastic runner attached to the window regulator. Even ordering a genuien window regulator doesn't come with the...

Did you ever get anywhere in finding out about this? I've noticed same coloring in smoke in my 2007 2.0 TDi 170 Quattro. In mine i get a really strong smell of diesel when idling, even if i'm just sitting at the lights. And the smoke is so bad that i had left the car in for wheel alignment...

Could you not do it yourself?, if you have a MFSW then I think that means your control module already has crusie control function, you just need to fit the cruise control stalk and get vcds coded. I did mine last year when i was fitting a FBMFSW.... cruise control was simple compared to fitting...

Cheers for the advise, left the car in with the local mechanic and he says he thinks it's the battery that needs replacing, will go down this route and see.

Cheers for the info Hollow, would you happen to have any info on the crank sensor? I gave the part number from the VCDS output to audi parts dept but they said it didn't exist for my car!

Cheers Leshkin, i've cleared the error code from the other night, so will do a rescan tonight and see if the error returns. Thanks for your help

Yes mate, sure did. Car has some of the symptoms from that wiki page. My issue is trying to find the part associated with my car. Doesn't seem to be much reported here about a Engine Speed Sensor, my local dealers say's its a VW part not present in Audi A3 8P :S. Only other article i have...

Address 01: Engine Labels: 03G-906-018-BMN.clb Control Module Part Number: 03G 906 018 DN HW: 03G 906 018 DN Software Coding: 0000172 Work Shop Code: WSC 06314 000 00000 1 Fault Found: 000801 - Engine Speed Sensor (G28)...

Having a bit of a hard time finding any information on this error. 2007 Audi A3 2.0TDI Quattro 170 Basically the car has been running sluggish for a few weeks, taking longer to turn over in the morning and a bit jittery/shaking at low revs until the car warms up. Then yesterday after being...

I'm pretty sure you just have to take of the plastic covering over the hazard light section then the AC unit just unclips. I did mine at the weekend there to remove the centre console and followed this guide http://audiretrofit.quinlivan.net/rs4startbutton ...steps 1, 2 & 3

Yeah I noticed those clips were the same on the gear shifter, but they're all accounted for... Its actually more annoying that I have this extra unaccounted for screw... Hopefully it's not that important :S.

Just to update on this, @OCD-A3 was 100% spot on cheers for the handy tip. Removed the centre console using the following guide http://audiretrofit.quinlivan.net/rs4startbutton Was very fidily to get off and even worse to get back on!!! Anyway once i had the centre console off i seen the...

Cheers for the info OCD, could be exactly what the issue is, will see about taking a look tonight. Cheers

The handbrake is pretty tight, it only goes up about 3 clicks. Problem is since the emergency stop the car thinks the handbrake is still engaged even though it's been fully released, so when I'm driving I get a very loud annoying warning sign for about a minute as the car thinks the handbrake is...

Had to pull an emergency stop tonight and applied both the footbrake and the handbrake. Now the Handbrake warning light is staying on the Instrument Dash and when i drive off i get the warning sound for around a minute as well as the Handbrake Is Applied DIS message. I've definitely fully...

Unfortunately i can't make it to this meet as i'm involved in a charity family fun day, hope it goes as well as the Belfast meet!

I just retrofitted a fbmfsw and cruise control stalk to my car yesterday, instead of buying a new bottom cowl i just cut the existing one and it worked out perfect. the way i looked at it, if i made a balls of it, i was going to be buying a new one anyway. I used the following guide and it...

Managed to get it sorted for anyone interested. Was a coding issue, i had long coded it for cruise control w/o onboard computer, just had to change it to cruise with onboard computer