Search results for query: *

I will give it a good check and see if needed... hopefully not

What was the labour cost for fitting?

I am currently thinking about replacing the oil pump balance shaft on my 07 A4 2.0tdi Avant 170bhp to the uprated version on sale by several companies on the net. The reason I am thinking about doing this is because my car needs a new turbo fitting and has done 84k miles so I suspect the hex...

The front wheel arches sometimes corrode.

If you can send a couple of pictures that would be great. Do you have the actuator as well? Tom

Couple of pictures confirming my turbo type:

Nice one... how much do you want for it? Tom

Hi All, I need to replace the Turbo on my 170bhp 2.0 Tdi A4... Has anyone fitted an aftermarket one or should I have it repaired? Audi want £1500 for one fitted. Cheers, Tom

I have my radio out at the moment so will check the fittings at the back, I'm looking to do the same install on mine. Tom

Wanted: S Line Grille (can be without chrome and badge) Fog Lights & wiring Loom (without PDC) Fog Light Grilles S Line. Offdside Front bumper bracket 8E0 807 204 B All above are for A4 Avant S Line B7 2007 Thanks Tom

done that everything looks ok, checked each plug... I'm going to take the centre console out and have a good look at the wiring loom from the module. I have a replacement airbag module I could fit and see if that makes any difference.

I've checked the glovebox switch and swapped it for a working one without any result. I've also cleared the errors and they keep coming back. Is the next step check all the wiring?

I've also got a problem with the ESP sensor unit, it doesn't seem to have and power getting to it. Could it be a faulty relay? 00493 - ESP-Sensor Unit (G419) 004 - No Signal/Communication Freeze Frame: Fault Status: 01100100...

Hi, I've got the following codes showing up on the Airbag module: 01228 - Airbag Cut-Off Switch for Passenger Side (E224) 010 - Open or Short to Plus - MIL ON Freeze Frame: Fault Status: 11101010 Fault Priority: 2...

yes I used the sealey locking kit VSE2358, the problem was the belt was slack going from the crankshaft to the water pump. I refitted the belt and tensioned it all up all working perfectly now. I was a bit worried as this was my first cambelt change so very pleased to have it all working as it...

Hi, I've recently replaced the cambelt, tensioners and water pump on my A4. The timing is showing 4.46 torsion value on vagcom and needs to be between 0-1???. Can someone clarify that both camshaft sprockets need adjusting or is it just the right hand side one? Thanks.

The fire was caused by the gear selector aluminum heat shield falling onto the exhaust down pipe and this caused the already degraded gearbox tunnel heat shield/insulation to set on fire. The reason the airbag went off was because the wiring to the module was damaged by the heat. I have fully...

Looking for some advice about replacing a drivers side curtain airbag on my 2007 A4 Avant 2.0 tdi. The wiring loom to the airbag module was damaged by a small fire setting the drivers curtain airbag off, I have fully repaired the wiring loom/fire damage and fitted a replacement airbag but...

Hi, My A4 2.tdi 170bhp needs a new engine loom. Will a A4 1.9tdi fit? Thanks.

Hi All, Not been on here for a while but I have recently changed from my 3.0 petrol B6 to a 2007 A4 2.0 TDI 170 AVANT I bought at a salvage auction with electrical problems. The problems I am having are as follows: When starting it cuts out after a couple of seconds The radio does not...