Search results for query: *

Yeah I’m conscious of the latch in my searches.

No it’s standard s line leather manual adjust with thigh extensions. I’ve got the climate panel with switches and harness for heated seats.

Yeah I did think I needed to lift the seats and have a look at what’s there. I was originally only going to get heated seats so wasn’t bothered for looking as I knew what was needed. I’m currently on with the head gasket and timing belt so will have to wait for now. I might still buy the ones...

Thanks for the info Rob on this thread. I’m contemplating buying some late B6 s line heated memory leathers for my b7 cab which are the same seat except full electric The seat module is with them as per your part number above. Am I right in thinking these will be plug and play except for...

Now sorted

Same issue for me, only 5V at the interior light.

Looking for some help with footwell lighting on my cab. I retrofitted footwell lights to my 2006 Avant using the interior light which work fine. However on my cab the interior light has a 5V feed for the door open trigger live. I’m thinking of using a door open live from the drivers door...

This common situation can be easily avoided when filling with new coolant On the B7. Unscrew the expansion tank from its mount, unclip the level sensor and raise the tank as high as you can whilst slowly filling. This method ensures the highest point on the system is the expansion tank. I...

I’ve recently completed this mod and had the same issue, the half leather was from a B6 in to mine which is B7. I transferred the seat belt holders from my stock s-line seats as they are wired on b7 but not on B6. I also transferred the seat pad sensor from the passenger seat. lights went...

I feel your stress! I had this last week on exactly same spec as your car. I replaced all four brake flexis on my Avant along with new cunifer tails on the front calipers and a joint to make on a seized union on the rear. All went quite well until bleeding the brakes. Used a pressure bleeder on...

I don’t know whether this is linked or not but when I retrofitted mine to my Avant the door lights worked but the mirror control ceased working! For some reason on mine where the earth pins were shared in the plug this happened but when earthed away from the pin everything worked! Might be...

Obviously not wanting the help offered then......

Bring it around here I’m in Leeds, I retrofitted both cruise and Washer level on mine.

I replaced my front full set of arms earlier this year and the only thing different with the s line was the track rod ends to standard which comes in the kit. Good luck with the pinch bolts by the way!

My compressor was totally wasted, I tested it off the car and the clutch just made the faintest click when 12v was applied. On replacement of the compressor I regassed the system and everything fired in to life. One thing for certain, you have a deffo fault if the econ light doesn’t switch off.

Recently repaired mine, had to do the compressor, pressure switch and condenser. I understood it if the compressor is faulty the fan doesn’t kick in, mine didn’t until I’d replaced the compressor.

Why not use a fuse piggy dash cam kit. Cost around £10, for the full kit.

It would have been a couple of weeks ago!

I’ve got this too after a full A\C refurb. I’ve bombed it on recirc but still have a smell. I’ve not noticed any run off under the car either when in use which should be happening.

Dodgy wiring plug on the A\C compressor.