Search results for query: *

No coding. It’s plug and play Sent from my iPhone using Tapatalk

The position of F40 can be shifted up to be in line with the other fuses. This controls hot all the time/ignition only. Sent from my iPhone using Tapatalk

There’s a fuse in the fuse panel that can be moved between 2 slots to control whether the socket is ignition only or hot all the time. It’s the same for a lot of VW/Audi. Sent from my iPhone using Tapatalk

Yes from the inside of the bumper on the left side. I was able to install it without removing the bumper. Sent from my iPhone using Tapatalk

Hope this pic helps. Sent from my iPhone using Tapatalk

You’ll notice that the posts that you screw the fog light into have some flex. The bracket holds the mounting posts more firmly. Sorry I should’ve clarified. The 8V5 number is for non S-Line sedan. The 8V3 part numbers you have are correct for the non S-line sportback. Sent from my iPhone...

They don’t mount to the fog lights. They mount to the inside of the front bumper. There should be a few tabs that you can see that the slots on the bracket line up with. Sent from my iPhone using Tapatalk

Door handle illumination is done via long coding in the door modules. No adaptations. Sent from my iPhone using Tapatalk

Per the Audi wiring diagram, the TPMS module is supplied from Fuse F7, 10A which is terminal 30 permanent power. Sent from my iPhone using Tapatalk

Based on the VCDS error shown, I’d say wire it to permanent 12V. Sent from my iPhone using Tapatalk

If you PM me an admap of 09 I’ll take a look. I only have PFL tho so not sure if it’s gonna be the same for you. Do you already have the MMI menu activated? Sent from my iPad using Tapatalk

Cars with LED headlights use T46b Pin 20 for the cup holder light. Sent from my iPhone using Tapatalk

How did you get red footwell lights? Aftermarket? Sent from my iPhone using Tapatalk

For those with the non S-line bumper, I do recommend getting the brackets. They snap in and hold the foglight more securely. 8V5-807-261 8V5-807-262

I don’t remember exactly where pin 2 is but it’s written on the connector. Sent from my iPhone using Tapatalk

Yes, I have it retrofitted. For xenon lights, you connect to T46B pin 2. Sent from my iPhone using Tapatalk

000979026E Sent from my iPhone using Tapatalk

For MMI control of the cupholder light, I have confirmed that these adaptation changes are correct: Wire the cupholder light into the middle connector BCM. T46B pin 2. 5F - Adaptations Vehicle function list BAP-interieur_light_0x08 = Activated Vehicle menu...

None of the coding instructions posted online work. These adaptations were taken from an admap of a car with the interior lighting package from the factory. Not sure what each individual change does but it works. Also, you need to long code byte 17, bit 2 in 09.

Pretty sure the door handle illumination is controlled by the dimmer from the factory so you can't control it with the MMI.