My valve cover gasket needs replacing and the last time I did this I also replaced the CCT gasket and half moon just by raising the CCT....
Does anyone have a rear brake caliper carriers knocking about? Need to be suitable for the wider 'vented' rear discs.
I think my S3 has a sticky rear caliper so considering a DIY replacement of both.
Can hose pliers be used on the short flexi's on the rear?...
Anyone else seen this?
So what's going on here then? The driver's side of the engine has dropped and I'm trying to pin point what has failed.
Excuse the pictures,...
Anyone else spotted this?
Quite a fair write up and actually...
The cam belt of my 2001 AMK was last changed in April 2012. Since then it has covered 25K miles.
Should I get it replaced as part of an...
Quick question. What's everyones opinion on these?...
I have a 2001 S3 AMK and at the weekend I was trying to fix some leaks with the PCV pipes under the inlet manifold. Yesterday, I tightened up...
Can anyone please confirm whether the standard catalytic converter incorporates the 6 `bolts` that secures the cat to downpipe?
Can anyone suggest who sells K04-023 10psi actuators for stock turbos.
Renewal time is upon me and thinking of fitting a FMIC.
I believe my current insurers (Admiral) do not insure cars modified with FMIC's.
I`ve had a jabbasport generic stage 1 remap on my AMK S3 since 2008.
I've slowly been getting parts together (new fuel pump，3“tip，...
I have an AMK S3 that has done 80k and has the following modifications:
'Generic' stage 1 map by Jabba from ~2007
I have recently carried out the below using various guides for my AMK S3:
replaced my injector inserts
ultrasonically cleaned injectors...
Going for a four wheel alignment at a local garage found on Welcome to Align My Car. They have a hunter dsp600 alignment machine.
Looking ahead at getting the S3 booked in for it's 80K service and cam belt changed.
So far I have been quoted:
'Full' service (inc...
I am sorry if this is the wrong section, but it is one of the most acive so thought I'd get the best response here.
I ordered a service...
I tried the method of holding the revs at 3000 and check to see if the mass air flow sits at 10g/s. It initially peaked at just over 10,...
I'm thinking of treating my S3 to some new 18" wheels. Currently I have some old style RSTT which I do like, but have been curbed so am...
Separate names with a comma.