Search results

  1. Johny2202

    My A6 3.0TDi Avant bit of a rebuild and repair thread.

    You don't need to remove rear lid trim you just need to unclip trim at top of rear lid and bit pull it down to release retainer of spring of high brake light.
  2. Johny2202

    My A6 3.0TDi Avant bit of a rebuild and repair thread.

    central electrics or convenience control module ?
  3. Johny2202

    My A6 3.0TDi Avant bit of a rebuild and repair thread.

    Why need to replace the central electric module?
  4. Johny2202

    heating issue

    What type of fault VAG com shows V50 coolant pump mechanical fault or electrical fault ?
  5. Johny2202

    MMI works but no led's or options menu?

    Hi, by VIN I can see that wrong control panel is fitted in your car. It must be version with 8 buttons but you have with 4 buttons. Correct part number- 4F2919611H.
  6. Johny2202

    a6 2.7tdi juddering/shakey on coldstart

    Did you checked the measure blocks of fuel injectors?
  7. Johny2202

    MMI works but no led's or options menu?

    Can you send in PM your VIN? It looks that wrong control panel is installed.
  8. Johny2202

    3.0 TDi CDYA engine code - engine coolant temp sensors

    There is two senders on these engines G83 Radiator outlet coolant temperature sender and G62 Engine coolant temperature sender. They both are senders not termo switch and connected to ECU. You can check them in measured blocks with VCDS. Do you have any problems with cooling?
  9. Johny2202

    MMI works but no led's or options menu?

    Can you take a picture with MMI control panel and screen. Before all was OK or you bought this car with this problem? Also you can send me WIN and I can tell what version do you have.
  10. Johny2202

    Nav question.

    Did you remove component protection? If not I think that this is the reason.
  11. Johny2202

    My A6 3.0TDi Avant bit of a rebuild and repair thread.

    It is not very hard to replace the belt without moving front in service position. :)
  12. Johny2202

    My A6 3.0TDi Avant bit of a rebuild and repair thread.

    I think you should go to work in AUDI factory make repair manuals for ELSA... :)
  13. Johny2202

    Audi A6 2.7 TDI Stereo Upgrade /Navigation

    I have most of units you need for MMI 2 high - MMI control unit, Display, radio unit, amplifier, navi unit, bluetooth telefon unit but I can tell you that upgrade to MMI high this will not be easy job as you need to make new all wiring...
  14. Johny2202

    c6 Door Blades

    My car is 2006 and it was one year ago I think you should go to Audi dealer and show your car them. https://www.audi.co.uk/owners-area/audi-insurance-warranties-and-service-plans/audi-warranties/audi-warranty-terms-and-conditions.html Anti-perforation warranty All current Audi vehicles are...
  15. Johny2202

    AUDI A6 2008 WIPER ISSUE?

    Hi, the most popular defect is that wiper arm axle gets stuck. Switch on wiper change position in MMI then switch off ignition and try to move wiper arm with hand it must move very easy if it moves with resistance then it is stuck. To solve this you must change wiper mechanism or stymie it and...
  16. Johny2202

    c6 Door Blades

    I had same problem on my A6 2006 and AUDI repaired it under WARRANTY. They replace all four door bottoms to version from facelift model and painted lower sides of all doors. If you fit bottoms from facelift version you must cut off old fitting pins from the doors and paint it.
  17. Johny2202

    Number plate lights

    4H0 943 021 and 4H0 943 022 are from Audi A 8 2011Y
  18. Johny2202

    Nav question.

    No need to replace front plate on Q7 unit you can just cut off edges as I did it.
  19. Johny2202

    Headlamp washer covers?

    From ETKA I can see that 2008 model Sline and non Sline models have same headlight washer covers and from 2009 they are different
  20. Johny2202

    Audi A6 2.7 TDI Stereo Upgrade /Navigation

    What MMI system do you have high or low?
Top