Assuming you have 2G high then there are kits like a mr12volt one out there. I have the kit for my 3g mmi and it works well. Simple replace the cd changer and you're away, for me it was actually plug and play surprisingly.
If you have 2g low with the red dot screen then maybe a 2g high would be...
Hi all,
As the title hopefully suggests the old foam on the underside of my engine cover has deteriorated and practically come off. Bar a new cover has anyone got any good suggestions to remedy this? Or even just removed the insulation and run the plastic cover without it?
Cheers.
Firstly this is the C6 forum, you might have more luck in the C7 for a 2015 model. :icon thumright:
Any number of reasons can cause the fans to come on and stay on more than expected, normal operation, interrupted dpf regen, faulty ac pressure sensor etc. A full scan would reveal if it is...
Hi,
The button on the fob should activate the boot latch, allowing you to pull or push the boot open. It does it when the car is locked, but I'm not sure if it still works unlocked.
The button in the car is in the drivers door pocket but was only installed if you had the power boot.
Below is...
To add,
There are 500 of these for the world, unless it's a garage queen and probably way out of my budget please let me know, the spec is just a nice to have and I'll probably shake your arm off if it has them all
I've decided to treat myself and after many years of lusting to buy one, if you have or know anyone who is considering selling, please let me know. It does have to be an Avant and a Plus.
Ideally, it would have the options, but I can be flexible;
ACC
Keyless
Sunroof
Black styling pack
Soft...
Normal upgrades you would expect are exhaust, intercooler(s) etc. You will run out of fuel system next which is injectors and the like. I've had a map on mine by Bobby at BSR Racing, he is a diesel guru and will probably be best to ask these questions to.
The limiting factor on these is the...
As already mentioned it's likely the ballast, the bulb looks correct and should be a D3S.
If you can swap the bulbs to confirm the issue is probably the ballast then that's a good start. It will require the bumper off to get the light out to get to the ballast unit. One of those while you're...
Anything's possible with enough time, patience and money.
In theory yes but I can't find anything on if it's been done before... everything except the full beam and indicator are different I think. The halogens will probably be worse for light output though unless your lenses are ruined, then...
I would follow the recommended service interval for the gearbox, usually, there is the using a diagnostic tool warm it up and check this and that. As for the filter I don't know.
As for the cambelt I would get it done, a lot of cars have a time period of 5-10 years as well as mileage, plus it's...
I wouldn't chase the voltage issue as if the car thinks there is a fault it won't bother to send enough voltage to turn it on. I can only think that there is a poor connection to the light for the brake only and that is causing the error. Try to chase the wire back and see if there are signs of...
Make sure the connectors are properly seated. If the car won't clear the faults it's likely because its test is still failing.
If you switch the headlights on do the rear lights also come on?
The car has likely logged you unplugging it and stored the fault, which means it won't try to even power the light until the fault is cleared or after a few ignition cycles. If you have a diagnostic tool try scanning for faults and clearing the ones for the lights if they are present.
Does anyone know what the map sensor on the CDYA engine (3.0 tdi) is rated to please? I think it's a 3 bar unit but I don't want to pull the front apart to check if someone knows.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.