Search results for query: *

  1. S

    APY lambda sensor

    Thanks for the info, that should save a bit of hassle then.
  2. S

    APY lambda sensor

    How many Lambda sensors are fitted to an APY engine as i can only find one located at the top of the down pipe beside the turbo, Do these engines only use one?
  3. S

    ECU required for apy engine

    because i live in ireland and road tax on a 2.8 liter is 1200 euro a year and the 1.8t is 500 euro per year. does this make sence to you now. Also a 1.8t in a 4motion will be a rare model, while it will also look oem as most of it is just a straight swap.
  4. S

    ECU required for apy engine

    I am looking for an ecu to suit an apy engine. It is for a conversion im doing at the moment. fitting the apy lump into a 4motion golf, Have the engine and loom but missing the ecu. Anyone here have one lying around? Please pm me or if you wish i can be contacted at 00353879574106.
  5. S

    S4 Budget exhaust

    Hi all, I have an S4 2.7T, was looking a these exhausts on ebay http://cgi.ebay.co.uk/97-02-AUDI-S4-B5-2-7L-V6-EXHAUST-CAT-BACK-SYSTEM_W0QQitemZ260503243083QQcmdZViewItemQQptZUK_CarsParts_Vehicles_CarParts_SM?hash=item3ca734094b Anyone one on here tried these and if so how do the rate them...
  6. S

    Avant/saloon exhaust

    thanks for the info.
  7. S

    Avant/saloon exhaust

    Quick question, Will an exhaust from a 98 avant S4 fit a 2000 model saloon S4?
  8. S

    Mk2 G60 for Px for S3

    Of course it would beat a rallye they are as slow as a wet week. Just finished fitting a Bam 20v into my mates rallye now it has a propper engine and is **** quick.
  9. S

    n75j or ecs race n75

    well if the ECS is the same as the H valve I see little piont in using the ECS valve then as it wont be any different to the the standard H valve
  10. S

    n75j or ecs race n75

    The N75h superceedes the N75c valve and are both the same valve and are used as standard on these engines. The N75j is taken from an audi S2 five cylinder 20v turbo. The connections for the boost and purge are on opposite sides on the J valve, so when fitting the valve to a A3,S3 the valve...
  11. S

    Haldex controller upgrade

    I have a pre facelift 1999 S3, I am looking to up-grade the haldex controller so as to put more drive to the rear wheels. What options have i got, am i looking at an aftermarket controller or a controller from a newer model. Anyone any info on this matter?
  12. S

    Water pump disintegration

    Its not that the plastic impeller pumps break up during normal use, they wear and start to spin on the centre shaft. In my experience they usually break when removing from the block when they are tight on the o-ring seal
  13. S

    Turbo Part No.

    Pre face lift model wont have an EGT sensor, K04-021 pre facelift (no EGT sensor) K04-022 Fitted to bam engines Has a EGT sensor. It will still work on a preface lift car just blank the hole for the sensor, you will need a 12x1mm pitch screw and sealing washer. I did this on a bam engine which I...
  14. S

    LSD Front and rear

    Limited Slip Diff
  15. S

    Coil pack yet AGAIN!

    Dont know what engine you have, but the newer type coil packs used on the bam engine are prone to failure, The hitachi coil packs (part no 06B905115, mounting screws N10117403 x8) used on the older apy engine are bullet proof and a full set will only cost around £100. especially on a remaped...
  16. S

    removal of S3 rear bumper plastic insert

    It should just unclip from the inside of the bumper with out any damage to paint work, but I dont think the new insert will come painted so you will have to have it painted anyway.
  17. S

    slam panel, head light trim.

    Picked up the head light trim's today and they are the correct ones. 8L0823738 RIGHT 8L0823737 LEFT They will need to be cut to the correct lenght as they are made to suit the A3 aswell.
  18. S

    which wheels on my red S3??

    S4 has a different PCD 112mm I think.
  19. S

    wtb a aftermarket exhaust system for 1.8t quattro

    I had a sebring cat back on my old S3, loved it, looked great, twin 90s and sounded even better. Just got another S3 two weeks I wont even consider any other exhaust when it comes to fitting one, its sebring for me.
  20. S

    CONCERT ll HEAD UNIT IN S3

    Well i orderd a can-bus simulator off ebay.de today for 27euro + postage 18euro to rep of ireland so I imagine postage will be the same for the uk. Cheap fix taking in to account I all ready have the head unit.
Top
Back