Think i regret buying my 2016 a6 avant. Should of kept my b7 a4 All was fine until i booked the car in with audi due to o/s/f cv joint was...
Mine is exactly the same i have tried new sensors too tends to be the two inner ones too
Got a 2016 A6 avant. Aircon recently has stopped working. Light on button will not come on and pump wont engage. I have plugged in another...
Yea drove it around and still its too high. It wont settle
Yep top mount is correct, and springs seated correctly. The front bottom arms have the ball joint pointing down through hub with nut on the bottom...
Finally had some time to spend on the car today. Tried this method and its still the same height as before. I cant work it out? The arms are the...
No i tighten them when in relaxed position. Is it just bottom arms i need to tighten when under compression? Best to do on level ground and crawl...
Spent all day saturday faffing around with them ****** pinch bolts on the front suspension. I have replaced all the arms, link arms and track rod...
Got a 2.0 tfsi. Oil pressure sensor wiring is completley dead. Only got a earth on the black wire. Green and yellow are dead. I take it this is...
my local engineer said he could repair that damage and also said this wouldn't be causing a knock. this video i have found on youtube is the same...
[IMG] [IMG]
Had a look again last night, the timing adjuster on the end of the cam has slight play in it is this ok? Also when i rotate the camshaft it gives...
Would you think the wear from the cam would cause the knocking? Also what would be causing it to do the same thing. I have used the orginal cams...
Been awhile since a update, i had rebuilt the engine, come across some issue on the way, slave cylinder seal blown, and leaky injector seals, fuel...
Got the bolt removed today by the bloke who is doing the head skim, he put the whole block in his press to hold it steady, and used a 3foot...
Head ordered and on its way, next problem, cant get the fricking crank bolt out. Snapped my breaker bar head, took the block to my mate, he tried...
I have sourced a cylinder head but it was removed of a BWA engine. Is there any differences between the two?
stripped the rest of engine down today, got down to head and block. two cam journals are damaged as pictured and blocked the oil holes in the...
removed the engine today all went smoothly. had enough time to wip off the sump and the cam cover. Rod Journals on the crank dont look bad,...
going to take the engine out on saturday, will post back with my findings :)
Separate names with a comma.
