If the bulbs in parallel are on but the LEDs arn't then it can only really be the LEDs that are at fault. On my car I have the older headlights...
With 6 ohm resistors you will be drawing 24W through them plug whatever the LED DRLs are taking. The car is expecting to only supply 19W. I would...
Maybe the blow off dump value is set at a much higher pressure than normal boost. Normally dump valves are to stop excess pressure not because it...
Also consider what happens when you come off the throttle or change up a gear. The VAG cars do not have an intake pressure sensor but instead work...
You might not be able to. If you want to run higher boost you might have to replace it with one of a higher rating. There is also a wastegate on...
The piston seals a hole between the air intake and the boost output of the turbo. When you lift off the throttle the ECU pulls back the piston to...
Coolant leak which is also letting air into the system causing an air lock?
I get around 300 miles to a tank. going to and from work which includes a couple of dual carriageways on the way back. On a longer run I get...
You will need to get the parts fitted and then get it towed to an Audi dealership and get them to program the new key into the immobiliser. You...
If the small resistor that is wired across the bulb has failed then the light will work but the system will think the bulb has failed as it is now...
My HID lights are prone to flickering at times which I suspect is a combination of old bulbs and a bit of moisture in the headlamp. Doesn't...
Under one of the front seats I believe.
I am not really sure. If only the regular lights are working then take a look at night by comparing them at the same angle. If there is a bad...
The first thing I would suspect would be a bad earth. If another light was on then the ground would not be at 0V so depending on timing etc... the...
What interface are you going to use with them. The VAG 1.1 software even if it supports the latest cars is going to require an interface which...
What do people use as boot mats to stop things sliding round all the time as you go round corners. My mat that came with the car is like...
As you are getting some bi-xenon headlamps from NHN these will need to be coded using VCDS anyway. Set them to 'Bi-Xenon with LED DRL'. Speak to...
My light switch has an auto setting on the rotary, a small thumb wheel switch to turn on the DRL to the left of it and a coming home light button...
I am sure it can be done. NHN is one of the retrofitting experts here and knows a log about VCDS so will know what options can be set and will...
On mine I bought a LED P21W from Trups (EM Tuning) and recoded to indicate the lights had LED DRLs. When you do this you remove the side light...
Separate names with a comma.
