Anyone had a chance to look at their nav/radio coding for RNSE? Could do with the cluster coding & channel 62 (infotainment). Changing the...
Back to its old tricks again this morning so recoding the Infotainment bus didn't work. :wtf: The coding hasn't changed. I swore a lot then went...
Ok, I was having another look at this pita fault. For the last few weeks, I've had the can bus high & low wires out of the quadlock so that...
Allyn, I realise the date on your post but did you get this sorted? Wondered if you wouldn’t mind sharing the coding for radio & cluster. I...
Not sure about the unit you’re looking to fit but I did have a similar aftermarket unit when I bought my B7. I fitted RNSE & one of the units...
I’ve managed to stop RNS-E drawing current with the key out (I replaced the radio board but it wasn’t that). No, I didn’t drop-kick it over the...
I found the alarm glass breakage sensors hiding behind the C-pillars. The pair of wires go into a connector behind the rear seat side trim on...
Does the temp gauge in the dash get up to 90 once you’ve been running for a few miles? What temp is the gauge at if the engine idles for a while?...
I don’t know about cabs but I’ve got a 2.0 TFSI. Would be worth checking the engine code of any you’re interested in & find out what’s been done...
This is the single wire connection at the top of the boot lid on the glass that's been mentioned on another forum. The track is only about 20cm...
[ATTACH] I can only find the rear window status & it shows here that it's in tact. I took all the boot trim off & I can't see the sensor. I...
Darren, I changed mine on my 1.9 AVF B6. I think this is what you're looking for so I've attached a pic for you to look at. My engine wouldn't...
Hi, my alarm keeps going off at random times when locked. Only the lights flash as I’ve already disconnected the siren from the alarm module in...
There is no AUX option on RNS-E. I’ve been checking the unit on the bench & it works fine. It doesn’t come on when it wants to or do random...
Thanks for the info, tcg. That’s some detailed right-ups you’ve done :icon thumright: I’ll post the results....
Thanks for your your reply, tgc. Interesting that you had a drain because of RNS-E. I’ll have another scan to see if the aux is enabled. Yeah,...
I've installed puddle & warning lights on my B7 & all the front door lights work as they should. My car was manufactured September 2006 so I'm...
I've installed puddle & warning lights on my B7 & all the front door lights work as they should. I didn't have to unplug anything. My car was...
....and while you're working out what's causing it, you might want to think about disconnecting the battery when you leave the car overnight or at...
If it's just a basic multimeter then the current setting may only be good for 300mA or so. If the current draw is high enough, then it could pop...
Separate names with a comma.
