Yes Cayenne calipers are a straight bolt on with merc ML 345mm discs Sent from my iPhone using Tapatalk
That does sound a bit steep more like £300 for the pair they’re not the easiest things to change. Sent from my iPhone using Tapatalk
The rear bearings on my B8 are 4 bolt hubs on my 2011 A4 Quattro Sent from my iPhone using Tapatalk
I thought the rear bearings was the same as front on a Quattro don’t quote me on that. But ye SKF or FAG fit cheap fit twice. Sent from my...
Check Air con pump and shaft they can break and it runs through engine mount! Sent from my iPhone using Tapatalk
I’d go for variable vains inside turbo mi self Sent from my iPhone using Tapatalk
You used to be able to buy an actuator that was coded I did for mine about 2 yrs ago swap them over set it up and away you go think the actuator...
Yes wiring loom in rubber boot done an A3 and A4 in last 3 weeks like is said be careful about 7/8/9 wires inside it good luck. Sent from my...
Ye it’s a little bit of work to check them and you need the proper timing tool if I remember right 1 side is worse than other to check some very...
Has the timing chains been done and not timed correctly??? Only reason I ask is I had an S4 come to me once that was pretty flat I checked all...
I had a problem with a 3.0 tdi Quattro a few years ago and the actual bush in the leg had come loose put 6 spots of weld on pressed it back in and...
Yes that is right it’s tight but can be done with patience also water pump can be done with bumper on very tight Good luck Sent from my iPhone...
Hi yes just link water pipes and blank each end off turbo end and inlet end not a straight forward job to remove as both inlets/swirl flaps have...
Looks like an M10 spline to me maybe M12 Sent from my iPhone using Tapatalk
Good work as always Bobby can’t wait for mine to be done [emoji106][emoji106] Sent from my iPhone using Tapatalk
Checked Autodata 3 hrs for front pair of shocks to change 1.6 hrs to change out the rear shocks Good luck Sent from my iPhone using Tapatalk
Ye I’ve seen that method I wouldn’t touch the dreaded pinch bolt I can only assume the garage is preparing for the worst I shall check the time on...
On the rear the spring sits separate to the shock I’ve done loads of B7’s but never a B8 yet but I’m guessing it’s a similar set up And on the...
Is it just shocks or shocks and springs ??? Once it’s on ramp you could change both rear shocks in an hour and I would hope an hour a side at the...
I would think yours is a non DPF model but they did start to trial them on 07 plates I’ve done dpf pressure sensor on a 3.0 tdi 57 plate. Sent...
Separate names with a comma.
