I would avoid those K nuts Merlin sells for this application, as they are not rated for very high temps.
You can get high temp ones from...
PM me an email address & I will send you the factory take on how to perfom a leak test at the TIP, & the max pressure to be used.
Hmm you say you they pressurized at the intake hose (TIP) to 30PSI !!!
That will be the cause of the smoke then & why it only suddenly...
Wow thats some bad run of luck, hope things improve for you.
I am guessing the actuator rod on the Forge unit is binding on the...
Thanks for your update, interesting stuff indeed.
Excellent news the turbine clipping appears to have eliminated any surge occuring,...
I would have personally thought with pressure reference/regulation removed from the actuator, & the white Forge spring boost would be a...
I think the actuators CR use "might" be Garret ones, although I am not 100% certain on this.
When I discussed the actuator behaviour with...
Hmm you would certainly kinda expect more boost than is being seen with that N75 DC even with the oddly behaving actuator.
Do you have a 118 log you can share Bill ?
Thanks for the update.
Indeed the compressor housing inlet is machined to a very thin wall thickness to accomodate the 2283 wheel.....
If you don't mind me asking do you know what caused your turbo failure yet ?
I am assuming its your compressor wheel that has...
My boost has always been controlled via the N75 with this hybrid... however previously in an "open loop" type manner.
Mapping wise very little has been done.. mainly due to it taking a back seat to customers vehicles, but also plenty of little...
Thanks for the comments.
Spool is certainly not any real issue as you note.. however I am experiencing some very light surging....
I am told the runners are 35mm.
Unfortunately I am still suffering a bit after the op... I just can't sit still & rest to let...
If you do find it then it would be most appreciated if you can point me too it, because if this was last year then the logs in theory...
Do you have any data or links you can share from the example(s) you have seen/heard about ?
As far as I know only two are actually...
You think the TSR one is not up to the job then ?
Or is it a cost/time scale thing that rules it out.
Firstly Welly I am very sorry to hear of your 034 mani issue, sounds like your luck is very similar to mine !
In regards the TSR...
I have taken a look at the logs Bill made as per your request.
Whilst I can see why Bill might think more timing could or should...
Separate names with a comma.