So iv had my AMK S3 around 18 months now. I bought it in standard form so I did the usual stage 1 stuff, cat back miltek, B5 V2.2 TIP, custom stage one remap at R-Tech, ST suspension.
After around 3 weeks after the map I started to get a misfire under boost, scanned for codes had misfire on cylinder number 1 so I changed plugs and coil packs, issue still there so I did the coilpack wiring loom. Misfire still there on cylinder number 1 so did a compression test and all was ok with that. Drove to work and on the way home it boiled up!
I got it home and decided to remove the head, I found the head cracked on 3 of the cylinders between the valves and from the valve to spark plug. Pics below.
So I decided to bite the bullet source an AGU engine and go BT
I removed the head from the AGU and Andrew at A.L.D has done a great job with the porting and polishing.
So the guys at badger 5 currently have my AGU head and block and are doing my GT35 stroker build
I will do a full spec in my build thread but the basics are
Badger GT35 stroker
SEM intake
Supertech valves and retainers
Badger cams
FMIC
Vibra-Technics engine mounts
HPA haldex controller
FIS control
HnR anti roll bars
Superpro bushes all round
Brembo's
Also got some other bit's on the cards like full respray, flat bottom steering wheel, 8p gearstick.
Looking forward to getting the car back up and running!
Shaun
After around 3 weeks after the map I started to get a misfire under boost, scanned for codes had misfire on cylinder number 1 so I changed plugs and coil packs, issue still there so I did the coilpack wiring loom. Misfire still there on cylinder number 1 so did a compression test and all was ok with that. Drove to work and on the way home it boiled up!
I got it home and decided to remove the head, I found the head cracked on 3 of the cylinders between the valves and from the valve to spark plug. Pics below.
So I decided to bite the bullet source an AGU engine and go BT
I removed the head from the AGU and Andrew at A.L.D has done a great job with the porting and polishing.
So the guys at badger 5 currently have my AGU head and block and are doing my GT35 stroker build
I will do a full spec in my build thread but the basics are
Badger GT35 stroker
SEM intake
Supertech valves and retainers
Badger cams
FMIC
Vibra-Technics engine mounts
HPA haldex controller
FIS control
HnR anti roll bars
Superpro bushes all round
Brembo's
Also got some other bit's on the cards like full respray, flat bottom steering wheel, 8p gearstick.
Looking forward to getting the car back up and running!
Shaun
Attachments
Last edited: