Logging Coding & Adaptations

coxy8329 · Jan 23, 2014

Hopefully somebody will be able to answer this.
Is it possible to log the coding and adaptation settings for the modules using VCDS?
Or is it a case of writing it all down by hand?

bearthebruce · Jan 23, 2014

Save an autoscan before you make changes. Save an autoscan after you make changes.

Also, changes you make are recorded in the log file as you make them. Check the Log folder in your VCDS installation.

NHN · Jan 23, 2014

As above, but you can do a controller map for adaption channels per module, some may require security access, I cant recall totally as been a while since I did.

coxy8329 · Jan 27, 2014

NHN said:
As above, but you can do a controller map for adaption channels per module, some may require security access, I cant recall totally as been a while since I did.

Thanks Nigel, I think that's what I need to do to record the Adaption settings for each module. Will see what I can find on the RossTech website.

bearthebruce said:
Save an autoscan before you make changes. Save an autoscan after you make changes.

Also, changes you make are recorded in the log file as you make them. Check the Log folder in your VCDS installation.

Thanks Bruce, I'd not noticed the 'Module Coding' had been recorded in the AutoScan Logs.

Search

Search

Logging Coding & Adaptations

coxy8329

Registered User

bearthebruce

Ross-Tech, LLC

NHN

Retrofitter - Audi - VW - Skoda - Seat

coxy8329

Registered User

Similar threads