20" Speedlines - on an 8P?
- Thread starter Dan320is
- Start date
JamesS4cab
Registered User
Stid pattern for 8P is 5x112 not 130 so by the time you hsve included adapters the etc would probably be too low.
Maybe 20" from an A/S6 or A8 etc?
Maybe 20" from an A/S6 or A8 etc?
Once you've used adapters the offset combined with the wheel width will make the Q7 alloys unusable. AFAIK only the Q7 came with the 20" versions (though I would live to be proved incorrect) 
Q7 will be ET60 and 9" wide, so there is room to fit adapters. 20x9 will be tough to get into the arches though, very limited in terms of fitting offsets.
I think the biggest 5x112 versions were 19x9 and there's a few 19x8.5 fitments.
I think the biggest 5x112 versions were 19x9 and there's a few 19x8.5 fitments.
Q7 has an ET of 55 to 45mm even with 15mm adapters (if you can find them) you'll be running a 9" wheel at ET40 at best.
timmythechef
Starin' Through My Rear View
You could run ET40 on a 9j. Would need to be slammed to pull it off though.
It needs to be at least ET47 to clear the strut.
It needs to be at least ET47 to clear the strut.
Speedlines for Q7 are 10x20 ET 44, so after adapters you are looking at 10x20 ET 29 or lower
