Hi All
Apologies
As I am extremely stacked out i do not have the time to follow this thread.
If your issue is not already addressed in the thread please drop me a message via my website
Also you will find videos on the site on how to manually operate the roofs
Regards
VagPro
Hi Mark,
Just seen all these posts now, as you can appreciate i do not have time to constantly check forums, so i future just contact me directly through website or eBay.
Sounds like you're sorted :)
Regards
Khurrum
Sent from my iPhone using Tapatalk
1) Test relays with 12v and multimeter
2) Test power to hydraulic pump units, wiring diagrams on page 1 of this post
Sent from my iPhone using Tapatalk
Hello,
To rectify the motor issue, you need to replace the brushes, cleaning and prying is only a short term solution....
Check the motor for continuity, is it open circuit? If not remove the motor and test with 12v (keep the pump vertical so fluid doesn't leak out)
If the motor works fine...
Hi David
Apologies for delay,madness at the moment with the weather, could be the switches Inside the assembly being intermittent, you moving things around has got them Working.
As they weren't working it's damaged the stops, replace the switch assembly and put loads of insulation tape to...
Hello David,
Sounds like it could be a switch position issue, the flashing light tells you there is a fault code stored in the controller, however the static codes do to always definitively identify the issue. You would need to loook at the love data in the roof controller. OBD readers would...
Hi John,
Dropbox has killed all the links and I am not allowed to amend the post anymore, there is a video on Youtube, but probably worth noting that the clean is a short term fix as the root causes is cracking brushes.
You need to replace brushes or fit a recon motor (not a new one or the...
Hello;
The bearing in the cover has moved out of line on its spherical, use a long similar diameter shaft to line it back up.
Point to note that cleaning is only a short term fix and the correct solution is to replace the brushes or obtain a recon motor (replace new brushes)
Regards
Khurrum...
I sell a brush kit on ebay, or offer a recon service.
In my opinion stay away from WD40, the brushes crack and swell, inevitable that they will not get stuck....
Sounds like youve already spent a bit of money, what was the driver to change all these parts?
Need to look at the live data to see whats happening using VCDS, where are you based?
Contact me through my site...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.