Recent content by Smithy23

Not sure if im correct but my part number on my map sensor is 038 906 051 C audi part number bosch number is 0 281 002 401 but after reading some thread ive came across someone with different part number. 038 906 051 D But think C is 3bar map sensor and D is 2.5 bar, not sure which one i need...

Thanks nluk Im not going to take it to garages Ill do all tests myself, even if I have to buy a pressure tester. at least I have it there for next time, Looking at all pipe work tomorrow in the day.

Car boosting better now but still not hitting target boost still not right, looking on boost pressure graphs done today the car has a stage 1 base map on it, still cant get to the bottom of this, Looking at the graph specified is asking for 1.3 1.4bar boost but im only actually getting 0.7bar...

But need vagcom to double check

No misfire. Might have solved issue going to double check tomorrow

Got car back from garage for weekend and going to dig into the possible causes above, anything i should look at while got car back?

Thanks for the help, I have researched and researched and it could be so many different things to make this happen. I did have one code come up when i first had car in for remap which i think was P0299 Boost Pressure Regulation: Control Range Not Reached but since I changed some valve its now...

It's a 2008 model

I've not seen repair to map sensor garage seen it when looking into issue. Only mod on car is a open air filter. Had a dv + mod but replaced now with new dv.

The n75 repair was because the connector clip was broke so put new one on. With electrical connectors. They have vagcom and only code it showed was something to do with boost limit not exceeded. Something like that. Here is some pics he sent me. He also said that if he seen this it would be...

I'm located in plymouth devon so pretty far away for alot of things. Going to call garage at some point today see how getting on. They know there way around an engine. Spoke to them couple of days ago and said by looks ecu asking for correct amount of boost pressure. But actuator not getting...

No didn't map. Had smoke tester on it. And didn't find any leaks

No they was not. As only could get them local on day. When car was in for mapping

I would if it was closer 5hrs away. Was hoping it was actuator not holding boost but it is. Going to recheck n75 today as wasnt a genuine one put on. And maybe map sensor because there is a repair done to wires

When checking spark plugs and coil packs. Spark plugs was pretty white.