It does have a part number which i posted above ^^ and it also fades to black so i’m happy with my purchase :D
i’ll post some pics...
On the back at the top it will be stamped with the part number and logo. Is it?
It looks genuine, I had the same silver one and it was...
Does anyone have any feedback on this ester based oil? I’m due my annual service and getting an ester based oil is really hard in New...
It was running 359/392 but dropping boost. The actuator is weak but I replaced the DV+ with Reg G on Niki’s advice and we...
Thanks for the replies.
I have always had Miltek always kept with what I know and the cars have always produced some good...
Yes, mine is mapped by RTech.
The back box on the Miltek is the restriction.
I’ll check mine tomorrow and let you know.
I have the P3 gauge with analogue boost controller so it will be reading pretty spot in....
R-Tech. Peaks at 32psi then drops back.
Typically I’m hitting 28/29 before it tapers back.
About 30psi at 5k tapering back 20-22.
Have you had the map tweaked for the new actuator?
ET45 is fine - you shouldn’t need spacers at all.
If you are running RS3 front wings then you could go 10mm which would give an...
That's even worse .
Poor 502.00 505.00
Medium 502.00 505.01
High 504.00 507.00
Separate names with a comma.