Recent content by Samuealle

Does anyone know the colors for the air bag in the seat to resistor it out? Mine for some odd reason has decided not to play the game. Clearing the code didn't do a lot and it came back on. The connectors are fine and ive traced the wiring back as far as I can and its intact. So does...

Air tools help. Having done the job 3 times helps too. Im used to working on beam line reactors and fusion torus' cars are childs play.

Well given my mrs is from Kenya i guess so.

Tell him to get felt! Its a 3 hour job. That's on a concrete drive not with the benefit of a 2 post lift and relevant lifting devices. Just one idiot and a couple of jacks.

For such a simple job id remove it for the sake of unnecessary weight.

Swapped some mirrors over today. Only way I could work out how to get it to sit in the rubbers correctly was to remove the inner sub frame and drop it all in together. Now my door cards have some awful fitment. Although I marked the position of the inner frame I think this is where the problem...

Pre facelift. Post face lift had them i think. Well my pre and post were like that. I'm committing sacrilege and putting pre facelift on post facelift.

Wiring to a sensor perhaps?

Buy some heat shrink too. Don't use electrical tape. Its **** in every way.

If you have intermittent boost I would be checking the line from the actuator to the n75 valve. Its an easy hose to twist and would provide the issues you have currently.

Just a thought. Has the door dropped and the hinges have just worn out. Take a look at the catch in the pillar and see if it has signs of wear.

Check your vac/pressure lines to the N75.

Full weight. A set of R888`s and stepping off the clutch at 5000rpm. 800mbar of boost on launch control certainly helps. I don't care about breaking things, that goes a long way to producing a decent time. Still want to see if I can get it to beat what my old skyline used to do on the 1/4. 11.1...

I didn't do inters but I have done a few runs in my car. BBT K418T Relentless V3 Manifold 3 Inch down pipe Decat 2.5 Inch exhaust Phenolic inlet spacer Pre throttle water/methanol injection Post throttle methanol injection IE Ultimate High flow head kit (But running on standard cams) Large...

Buy another parcel shelf....and throw those 6x9`s in the bin. Put a 4 channel amp in the back and run wires through to your speakers in the front. Swap the door speakers for a decent set of second hand door speakers mounted on mdf rings and get some sound deadening. Apply this to the inside of...