Recent content by mikrt

My EGR is throwing up a few errors, with EML on also. It's a 2015 2.0D 150 BHP engine code CUVC. I've been reading on sites that after some VAGs have been in for recall software update work to fix the emmissions, that they have been fixing FOC EGRs which are then faulting after work is carried...

Yes, logical and obvious - thanks. But not the question posed. I was just asking if anybody knew why there was one a different size, and/or if it should be.

Hi, problem with my daughter's car, a 2015 150bhp, and I'd really appreciate some advice on it, Engine management light came on, indie plugged it in and diagnosed a faulty glow plug. Ordered a full set of 4, but when came to fit them, 1 of the ones already fitted was of a different size (No 3...

I have a 58 plate cabrio A4 and would like to install (if possible) whatever I need to make it bluetooth handsfree. On other, earlier cars, I've fitted different Parrots and been please with them. But, I understand my car can be fitted with a module/leads to make it work off the steering wheel...

Thanks all..... 36 all round it is

:sunglasses:

Thanks mr.raw, but did you note mine is a cabriolet, the plate Tashfeen posted was a saloon.

Thanks again Tashfeen, I had already tried Kwikfit, but mine were 16" as standard so that's what's coming up. But then I had a brainwave - I went onto ebay and searched for all the B7 2.0 TDI cabriolets with 18" tyres and bingo! Using their reg numbers I got success. Weirdly, of the 20ish I...

Thanks for that Tashfeen, but your sticker is the same as the saloon one I posted, mine's a cabriolet and is a lower psi.

Have just got my car on the road. The car already had 235/40/18 wheels/tyres on, but the sticker is only for 16" & 17" Please see my sticker I can find another sticker for a saloon with 16", 17" & 18" details, please see sticker And I can see that the saloon @ 18" is +3 psi @ low load...

Yes, it has DIS.

And just to confirm.. It was coded using SnapOn

Road test complete.......... Cruise is working a treat, thanks you all so much, especially SemedoB6 :salute: Next job, in a few weeks is rear parking sensors.

The car is in garage a few miles away, and I wouldn't have a clue where to start.... But the young fitter who used the Snap On to code, used the up & down to test at the end - as per the last 2 photos of instructions in this opening post, and it worked. So if it won't engage below 20mph I'm...

Planned yellow connector check yesterday didn't happen, but got it sorted this morning. I HAD TO cut off 5mm of the outer cover of the said yellow connector to get it in. The tab didn't feel 100% when in position, so I've used a very thin cable tie to aid with securing it. Good news as the...