Recent content by maniasg

So if im not wrong those are right code's for bilstein 24-262309 24-262323 ? @ WesT-gefül you already have b12 pro kit installed? It will be tougher in puddles with bilstein?

I didn't take any photos before sorry...car is 2cm lower but its enough....i feel it more smoothly but its jumping a lot i think... that's why im thinking of sport suspension....but i don't want to became very hard either

So springs came and installed...car looks beautiful but i thinks it will be better with a sport suspension :) Any suggestions for suspension? Bilstein or something else that will fit with eibach pro kit ?

Its says for A3 ? Its suitable for me? I cant find how to send you pm ...if possible send me i would like to ask you some things :)

So I'm back ...i check everything today canbus hi low , 12v , ground cable .... everything are correct and work properly....but camera reacts same sh***t ....its coding issue but what???

So i know from the seller that i have: red: power, black: ground, yellow: video+ green canbus hi white canbus low I'll check if pins are correct as you said ...thanks again for you time and for you help....i will inform you :)

Ok i will check behind dvd if are correct and i will tell you

From which side shall i try ? From the trunk handle or front dvd unit ?

I contacted with seller he send those photos....i read somewhere else that maybe CAN-high & CAN -low wires have to be reversed thats why 6C module cant be registered... I'll try it later on.... red: power, black: ground, yellow: video+ green and white canbus hi/low

Im afraid that it doesn't work because i dont have rear parking sensors...

Also a lot that they say that fits.... anyway yes purple wire has 6 pins...today i have noticed that camera also works for 10 seconds when i start the car and select R....its working during mmi boots or reset but when mmi finally open camera stop working

Its this camera supposed to be plug and play ...just one cable

How did you register 6C ? Obdeleven or ?

Step by step: Select 19 Gateway Select Adaptation Select Installation list, specified installations Search „camera” in the list and check Coded and then Slide to write Select 09 Central Electrics Select Long Coding (Attention! Do a full backup of your current long coding number before any new...

So i following Bogdans guide but i have those errors and 6C module is black and i cant change anything in it...