Recent content by Lee Goodall

Yeah, it was supplied by Turbo Dynamics, I was really impressed with their service. They did give me a bit of discount too.

That's for everything and includes a new actuator too.

I paid £570 including delivery but I think they are usually slightly more.

New shiny GT28R has been delivered!

I replaced the cam chain tensioner gasket and half moon seal yesterday. The old seal was looking worse for wear and leaking down the back of the cylinder head. I was planning on getting more photos and doing a bit of a write up but time was against me unfortunately.

Cheers, that's what I assumed. I'm running a 200cell at the moment too.

Cheers for the info Slepy. I have seen a few sites that specify the design (bar and plate or tube and fin). I'll make sure that the one I get is bar and plate.

The old GT28R (GT2560R) was beyond repair so I've ordered a brand new one for delivery Monday. I will be replacing the cam chain tensioner gasket over the weekend, after this I plan to get a new downpipe back exhaust system installed and then MOT. What are peoples thoughts about performance...

Ok, cheers. I'll get a larger intercooler ordered then. How do you rate the quality of yours?

So... is my 50mm intercooler going to need replacing or should I just increase all of the pipework and use reducers to make the connection to the intercooler? I know ideally I should upgrade but is it essential for the sort of figures that I'm aiming for (290HP ish)?

Good work mate. Very informative.

I'll be interested to see how you get on.

Cheers for the info.. looks like I'll be ordering a load of new hoses too then.

So do I need to increase the size of my intercooler hoses? It's a job that I could do without to be honest!

Ordered a heat shield for my Green filter today..